Question is ⇒ There is no radiation at right angles to the plane of the array, is end fire array., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ There is no radiation at right angles to the plane of the array, is end fire array., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	There is no radiation at right angles to the plane of the array, is end fire array.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ A cycloconverter cannot give a frequency higher than input frequency.
TRUE
FALSE

⇒ For a series circuit of variable R and X_L, the impedance locus is
a straight line parallel to X axis in first quadrant
a straight line parallel to X axis in fourth quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ A mode-10 counter can divide the clock frequency by a factor of
10
100
1000
10000

⇒ Which of the following statement regarding waveguides is incorrect?
At waveguide can be coupled to a coaxial cable
At frequencies below the cut off value the wave progresses across the waveguide after total reflections
Waveguides are usually air filled hollow conducting metallic tubes for transmitting UHF and microwaves
Waveguides can handle large power at UHF and microwaves

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ The changes in ambient temperature affect the open loop gain of amplifier.
TRUE
FALSE

⇒ A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
230 V
0.5 x 230 V
2 x 230V
230/2V

⇒ The spins in a ferrimagnetic material are
all aligned parallel
partially aligned antiparallel without exactly cancelling out sublattice magnetisation
randomly oriented
all aligned antiparallel such that the sublattice cancels out exactly

⇒ In computers the size of secondary memory is usually much larger than that of primary memory.
TRUE
FALSE

⇒ The nodal method of circuit analysis is based on
KVLs, ohm law
KCLs, ohm law
KCLs, KVL
KCL, KVL, ohms law

⇒ Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit?

A flip-flop is always a digital circuit.
Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit.
Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit.
Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.

Select the correct answer from the codes given below:
1 only
2 and 3
2 only
3 and 4

⇒ The equivalent form of the logical expression ABC + A BC + ABC + ABC + AB C is
C + (A ⊕ B)
(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒ The modulation of effective base width by collector voltage is known as Early effect, hence reverse collector voltage
increases both a and β
decrease both a and β
increase a but decrease β
decrease a but increase β

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ A buffer amplifier is
a double-tuned amplifier
a high gain D.C. amplifier
a cathode follower stage
none of the above

⇒ For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is
output voltage
input voltage
voltage drop across thyristor
none of the above

⇒ A proportional controller is basically
an amplifier with adjustable gain
an integrating amplifier
an amplifier with infinite gain
an amplifier with almost zero gain

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
6 k
3 k, 6 k
9.9 k, 2.4 k
2.4 k, 9.9 k

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region