Question is ⇒ There is no hysteresis phenomenon is any dielectric material., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ There is no hysteresis phenomenon is any dielectric material., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	There is no hysteresis phenomenon is any dielectric material.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The effective height of an antenna is slightly greater than physical height because
wave velocity in conductor is less than its velocity in free space
wave velocity in conductor is more than its velocity in free space
resistance of conductor is less than that of free space
none of the above

⇒ Which of the following best represents the output impedance of an actual op-amp?
10 ohm
100 ohm
10 k ohm
100 k ohm

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ In a parallel inverter
each thyristor is turned on twice during each cycle
each thyristor is turned on once during each cycle
each thyristor is turned on either once or twice in each load cycle
each thyristor may be turned on upto four times in each load cycle

⇒ A delta connection contains three impedances of 60 Ω each. The impedances of equivalent star connection will be
15 Ω
20 Ω
30 Ω
40 Ω

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ Consider the following statements

Acceptor level lies close the valence band.
Donor level lies close to the valence band.
n type semiconductor behaves as an insulator at 0 K.
p type semiconductor behaves as an insulator at 0 K.

Of these statements:
2 and 3 are correct
1 and 3 are correct
1 and 4 are correct
3 and 4 are correct

⇒ The decorative lighting works on the principle of
periodic switching on and off
special inverter
rectifier
motor

⇒ Two coupled coils lie in parallel planes such that 50% of magnetic flux produced by one links the other. The coefficient of coupling is
0.5
0.25
0.125
0.5

⇒ A voltage wave v = 10 + 20 sin ωt + 7.5 sin 3 ω(t) is applied to a series combination of two elements. The current is i = 5 sin (ωt + 20°) + 1.5 sin (3ωt + 10°). The elements are
R and C
R and L
L and C
both inductances

⇒ In the circuit of figure, the value of r_e is (neglecting v_{be100 Ω
75 Ω
50 Ω
25 Ω}

⇒ Highest value of autocorrelation function 100 sin 50 pt is
50
zero
100
100/p

⇒ The amount of time between the creation and disappearance of a hole in an intrinsic semiconductor material is called
life cycle
recombination time
life time
half life

⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit

⇒ For the circuit shown in the figure, D has a transition from 0 to 1 after CLK changes from 1 to 0. Assume gate delays to be neglig
Q goes to 1 to the CLK transition and stays at 1
Q goes to 0 at the CLK transition and stays at 10
Q goes to 1 at the CLK transition and goes to 0 when D goes to 1
Q goes to 0 at the CLK transition and goes to 1 when D goes to 1

⇒ Coulomb friction is
the force of sliding friction between dry surfaces
the force of friction between moving surfaces separated by viscous fluid
the force required to initiate motion between two contacting surfaces
all of the above

⇒ The component in the given figur
attenuator
T type low pass filter
T type high pass filter
phase shifter

⇒ The polar plot of G(jω) = 1/jω is
positive imaginary axis
positive real axis
negative imaginary axis
negative real axis

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The increase in intensity of trace in a CRO causes a change in
beam current
frequency of time base
gain of Y amplifier
accelerating voltage

⇒ In a circular waveguide the dominant mode is
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ Which of the following subtraction operations do not result in F₁₆?

(BA)₁₆ - (AB)_{161 and 2
1 and 3
2 and 3
1, 2 and 3}

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒
Match the following:
List I List II
A. Silicon 1. is trivalent
B. Arsenic 2. rarely used as semiconductor
C. Indium 3. is pentavalent
D. Germanium 4. intrinsic semiconductor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4

⇒ Efficiency of a half wave diode rectifier is less than 40%.
TRUE
FALSE

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ A noiseless 3 KHz channel can transmit binary at the rate __________ .
12000 bps
10000 bps
6000 bps
3000 bps

	List I		List II
A.	Silicon	1.	is trivalent
B.	Arsenic	2.	rarely used as semiconductor
C.	Indium	3.	is pentavalent
D.	Germanium	4.	intrinsic semiconductor