Question is ⇒ The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts, Options are ⇒ (A) 23.7 mA, (B) 14.2 mA, (C) 13.7 mA, (D) 24.2 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts, Options are ⇒ (A) 23.7 mA, (B) 14.2 mA, (C) 13.7 mA, (D) 24.2 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts
A.	23.7 mA [Wrong Answer]
B.	14.2 mA [Wrong Answer]
C.	13.7 mA [Wrong Answer]
D.	24.2 mA [Correct Answer]
View Answer 1 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): An on off controller gives rise to oscillation of the output between two limits.

Reason (R): Location of a pair of poles on jω axis gives rise to self sustained oscillations in the output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ Consider the signal S(t) shown bel
8
12
16
18

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒ Personal computer cannot be used for which one of the following?
Game playing
Weather forecasting
Office Automation
Home computing

⇒ If B = 4 + j3, (B)^1/3 =
2 ∠30°
2 ∠36.87°
1.71 ∠12.3°
1.71 ∠30°

⇒ The range of a cordless telephone is about
1000 m
500 m
100 m
10 m

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒

Assertion (A): In rectangular waveguide TE₀₁ mode is just TE₁₀ mode rotated by 90°.

Reason (R): When a rectangular waveguide is rotated by 90°, the broad and narrow dimensions get interchanged.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ UHF range is
3 to 30 MHz
30 to 300 MHz
300 to 3000 MHz
3000 to 30000 MHz

⇒ An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is
OFFFH
1000H
B9FFH
BA00H

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ A 4 bit modulo 16 ripple counter uses JK flip-flops. If the propagation delay of each FF is 50 ns. The max. clock frequency that can be used is equal to
20 MHz
10 MHz
5 MHz
4 MHz

⇒ For air filled circular waveguides
the attenuation due to imperfect conducting walls is negligible
the attenuation due to imperfect dielectric is negligible
both the attenuation i.e. due to imperfect conducting walls and due to imperfect dielectric are significant
the total attenuation is almost zero

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ For the network shown, determine z₁ , z₀ and A_{vz_i = 1.067 Ω; z₀ = 3 kΩ; A_v = 280
z_i = 1.067 Ω; z₀ = 3 kΩ; A_v = - 280.37
z_i = 937 Ω; z₀ = 3 Ω; A_v = 281
z_i = 937 Ω; z₀ = 33 kΩ; A_v = - 280.37}

⇒ A series R-C circuit with R = 3 Ω and X_C = 4 Ω at 50 Hz is supplied with a voltage V = 50 + 141.4 sin 314 t. What is the RMS value of the current flowing through the circuit?
0.208333333333333
0.416666666666667
20 A
22-36 A

⇒ A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. The frequencies present in the output will be
998 kHz and 1002 kHz
998 kHz, 999.2 kHz, 1000.8 kHz, 1002.0 kHz
998 kHz, 999.2 kHz, 999.7 kHz, 1000.3 kHz, 1000.8 kHz and 1000.2 kHz
none of the above

⇒ Tuned amplifiers are used at radio frequencies.
TRUE
FALSE

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒ The circuit shown in figure conv
BCD to binary code
binary to excess-3 code
excess-3 to Gray code
gray to binary code