Question is ⇒ The V<sub>s</sub> is give, Options are ⇒ (A) 8 V, (B) 13 V, (C) 1 V, (D) 4 V, (E) , Leave your comments or Download question paper.

Question is ⇒ The V<sub>s</sub> is give, Options are ⇒ (A) 8 V, (B) 13 V, (C) 1 V, (D) 4 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The V_s is give
A.	8 V [Wrong Answer]
B.	13 V [Correct Answer]
C.	1 V [Wrong Answer]
D.	4 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The basic shift register operations are
serial in - serial out
serial in - parallel out
parallel in - serial out
all of the above

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ Leak type bias is used in plate modulated class C amplifier to
increase the bandwidth
prevent over modulation
prevent excessive grid current
prevent tuned circuit damping

⇒ Which of the- following display consumes least amount of power?
LCD
LED
Fluorescent display
All display consume same power

⇒ In an AM wave the carrier and one of the side bands is suppressed. If m = 1, the percentage saving in power is
0.25
0.5
0.666
0.833

⇒ The distance between maxima and minima of a standing wave is
λ/4
λ/2
λ
2λ

⇒ Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
reduced losses
high bandwidth
reduced losses and low bandwidth
more losses and low bandwidth

⇒ PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is
2 kHz
4 kHz
8 kHz
16 kHz

⇒ Minute cracks in metals and minute faults in welded joints can be detected using
IR rays
UV rays
a rays
X-ray/γ-rays

⇒ All digital circuits can be realised using only
EX-OR gates
Multiplexers
Half adders
OR gates

⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ In a synchronous counter all flip flops are clocked together.
TRUE
FALSE

⇒ A moving iron instrument gives correct reading when used at
low frequencies
high frequencies
only one frequency
all frequencies upto a certain value

⇒ The intrinsic carrier concentration of silicon sample at 300 K is 1.5 x 10¹⁶/m³. If after doping, the number of majority carriers is 5 x 10²⁰/m³. The minority carrier density is
4.5 x 10¹¹/m³
3.33 x 10⁴/m³
5 x 10²⁰/m³
3 x 10^-5/m³

⇒ Consider the following statements

The amplitude of an FM wave is constant
FM is more immune to noise than AM
FM broadcasts operate in upper VHF and UHF frequency ranges
FM transmitting and receiving equipments are simpler as compared to AM transmitting and receiving equipments

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ V_R at t < T, t = &in
500e^-40x10⁴t, 0
100e^-40x10³t, 0
100e^-40x10⁶t, 0
100e^-40x10⁴t, 0

⇒ The most widely used LC oscillator is
Hartley oscillator
Crystal oscillator
Colpitt's oscillator
Clapp's oscillator

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ A resistor R of 1 Ω and two inductor L₁ and L₂ of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L₁ and L₂ are 1 A and 2 A, respectively. The current through R at time t = ∞ will be
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ The typical squelch circuit
cuts off IF amplifier when AGC is minimum
cuts off IF amplifier when AGC is maximum
cuts off audio amplifier when carrier is absent
eliminates RF interference when signal is weak

⇒ A network is causal if impulse response is zero for t < 0.
TRUE
FALSE

⇒ The antenna most commonly used for TV broadcasting in the UHF band is
turnstile antenna
dipole antenna
yagi antenna
rhombic antenna

⇒ In a synchro transmitter-control transformer, the voltage induced in rotor winding of control transformer is zero when the angular displacement between rotors of transmitter and transformer is
0°
90°
180°
either (a) or (c)

⇒

Assertion (A): A balun is an RF impedance matching transformer.

Reason (R): Sometimes a booster amplifier is used with a TV set.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In telephone systems, load is expressed in the unit of
erlangs
decibels
bells
watts

⇒ Rochelle salt is a ferroelectric material.
TRUE
FALSE

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ A BJT is said to be operating in saturation region if
both junctions are reverse biased
both junctions are forward biased
base emitter junction is forward biased and base collector junction is reverse biased
base collector junction is forward biased and base emitter junction is reverse biased

⇒ Computers use thousands of flip-flops. To coordinate the overall action, a common signal is sent to all flip-flop known as
debug signal
toggle signal
active signal
clock signal