Question is ⇒ The voltage across a zener diode, Options are ⇒ (A) is constant in forward direction, (B) is constant in reverse direction, (C) is constant in both forward and reverse directions, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The voltage across a zener diode, Options are ⇒ (A) is constant in forward direction, (B) is constant in reverse direction, (C) is constant in both forward and reverse directions, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The voltage across a zener diode
A.	is constant in forward direction [Wrong Answer]
B.	is constant in reverse direction [Correct Answer]
C.	is constant in both forward and reverse directions [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz. The wave impedance is
400.94 Ω
562.94 Ω
502.80 Ω
492.80 Ω

⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is
changing
reversing
steady
alternating

⇒ A frequency multiplier stage should operate as
class A
class B
class AB
class C

⇒

Assertion (A): For an underdamped system with damping ratio ξ, the maximum overshoot is e-ξp/(1-ξ²)^0.5

Reason (R): Peak time of a second order under damped system = p/ω_d where ω_d is frequency of damped oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The following Variable Entered Map (VEM) represents which of the following funct
f(A, B, C, D) = ∑(1, 2, 3, 4, 7, 8, 9, 14, 15) + Φ(3, 5, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 8, 10, 8, 13, 15) + Φ(3, 6, 12, 14)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 10, 13, 15) + Φ(6, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 9, 12, 13) + Φ(3, 5, 14, 15)

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ A string of series connected thyristors needs equalising circuit to
ensure proper firing
ensure proper current division
ensure proper voltage division
none of the above

⇒ The value of current at resonance in series R-L-C circuit is affected by the value of
C
L
R
all of the above

⇒ Consider the following statements about data structures in Pascal

Arrays and files are types of data structures.
List structure is not a data structure in Pascal.
Each element of a binary tree is called a node of the tree.

Which of the above are statements correct?
All
1, and 2 only
1 and 3 only
2 and 3 only

⇒ In ALU 1C 74181 the addition and subtraction is in
2's complement
1's complement
binary
none of the above

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10⁸ m/sec
5 x 10⁸ m/sec
3 x 10⁸ m/sec
1.5 x 10⁸ m/sec

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ __________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch
toggled, delay
delay, toggle
set reset
reset, set

⇒ In a low level AM system, the modulated amplifiers stage must be
harmonic devices
non-linear devices
class C amplifier
linear devices

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒ The pole-zero configuration of the given figure can be
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ PROM is
Permanent Read Only Memory
Polarized Read Only Memory
Positive Read Only Memory
Programmable Read Only Memory

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ The scale of hot wire ammeter is
linear
non-linear
cramped
absolute linear

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ Watthour meter is an integrating instrument
TRUE
FALSE

⇒ In a bipolar transistor
the base is thick and highly doped
the base is thin and highly doped
the base is thick and lightly doped
the base is thin and lightly doped

⇒ Which family of logic circuits uses field effect transistors?
TTL
CMOS
Both LED and well as LCD
None of the above

⇒

Assertion (A): At room temperature the fermi level in p type semiconductor lies nearer to the valence band and in n type semiconductor it lies nearer to the conduction band.

Reason (R): At room temperature, the p type semiconductor is rich in holes and n type semiconductor is rich in electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A certain JK FF has t_pd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is
any
8
256
10

⇒ In an ac network the sum of currents entering a node is 10 ∠45°. The sum of currents leaving the node is
19.32 ∠45°
15 ∠45°
20 ∠45°
zero