Question is ⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded, Options are ⇒ (A) The diode is a silicon diode, (B) The diode is a germanium diode, (C) Break down voltage of the diode is 0.7 V, (D) At 1 V rated current will pass through the diode, (E) , Leave your comments or Download question paper.

Question is ⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded, Options are ⇒ (A) The diode is a silicon diode, (B) The diode is a germanium diode, (C) Break down voltage of the diode is 0.7 V, (D) At 1 V rated current will pass through the diode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
A.	The diode is a silicon diode [Correct Answer]
B.	The diode is a germanium diode [Wrong Answer]
C.	Break down voltage of the diode is 0.7 V [Wrong Answer]
D.	At 1 V rated current will pass through the diode [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In most of instruments, the controlling torque is provided by
fluid fraction
spring
eddy current
either (a) or (c)

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ In a normally biased N-P-N transistor the main current crossing the collector junction is
a drift current
a hole current
a diffusion current
same as the base current

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ Program counter in a digital computer
counts the number of programs run in the machine
counts the number of times a subroutine
counts the number of time the loops are executed
points the memory address of the current or the next instruction

⇒ The minimum gate current which can turn on SCR is called :
trigger current
holding current
junction current
breakover current

⇒ Which of the following is not an internal DOS command?
VER
COPY
MEM
DATE

⇒ The V_s is give
8 V
13 V
1 V
4 V

⇒ In the circuit of figure for sinusoidal input the waveform of the output will be as show
figure A
figure B
figure C
figure D

⇒ A TEM wave incident obliquely on a dielectric boundary with ε_r1 = 2 and ε_r2 = 1, the angle of incidence for total reflection is
30°
60°
45°
90°

⇒ Ferroelectric materials are those which
cannot be polarized
have a permanent polarization
have a_e equal to zero
have μ_p = 0

⇒ In a CRO, the time base signal is applied to
X plates
Y plates
either X or Y plates
alternately X and Y plates

⇒ A digital clock uses __________ chip
SSI
LSI
VLSI
MSI

⇒ Two capacitors of 2 μF and 4 μF capacitance are connected in series across a 30 V dc battery. After the capacitors have been charged, the voltage across them will be
15 V each
10 V and 20 V
20 V and 10 V
30 V each

⇒ The zinc can of a dry cell serves as positive terminal.
TRUE
FALSE

⇒ Consider the following

A signal f(t) and its Hilbert transform f_h(t) have the same energy density spectrum
A signal f(t) and its Hilbert transform, f_h(t) have the same auto correlation function
A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only

⇒ The range of floating point numbers in Java is
1.4 E - 45 to 3.4 E + 38
3.4 E - 45 to 1.4 E + 38
1.4 E - 38 to 3.4 E + 45
3.4 E - 38 to 1.4 E + 45

⇒ The timing difference between a slow memory and fast processor can be resolved if
processor is capable of waiting
external buffer is used
either (a) or (b)
neither (a) nor (b)

⇒ It is very likely in __________ gate family that when one gate is driving number of gates in __________ , a gate having least voltage for saturation may consume large __________ leaving other gates inoperative and this phenomenon is called __________ .
DTL, parallel, current, current - sinking
DCTL, parallel, current, current-lagging
ECL, series, voltage, voltage-deterioration
DCTL, series, current, current-lagging

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒

Assertion (A): The circuit of figure thyristor will conduct for 180° during positive half cycle if it is continuously fir
Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Read the following statements about files in Pascal

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1 and 3 only

⇒ The initial contents of ACC and CY in 8085 are

CY = 1
ACC = 10000001

After instruction RAL is executed once the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000011
1 and 00000001
0 and 00000001

⇒ The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.
5
240
2
2880