Question is ⇒ The value of operator j2 is equal to, Options are ⇒ (A) Zero, (B) +1, (C) -1, (D) √<span style="border-top: solid 1px #000000">-1</span>, (E) , Leave your comments or Download question paper.

Question is ⇒ The value of operator j2 is equal to, Options are ⇒ (A) Zero, (B) +1, (C) -1, (D) √<span style="border-top: solid 1px #000000">-1</span>, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The value of operator j2 is equal to
A.	Zero [Wrong Answer]
B.	+1 [Wrong Answer]
C.	-1 [Correct Answer]
D.	√-1 [Wrong Answer]
View Answer 9 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ How much r.m.s. current does a 300 W. 200V bulb take from the 200 V, 50 Hz power line ?
0.5A
1.5 A
2A
3A

⇒ Poor power factor results in all of the following EXCEPT.
Overloading of transformers
Overloading of altemators
Reduction in power losses
Reduction in load handling capacity of electrical system

⇒ The power taken by a 3-Φ load is given by the expression
√3 V_L I_L sinΦ
√3 V_L I_L cosΦ
3 V_L I_L sinΦ
3 V_L I_L cosΦ

⇒ All the rules and laws of D.C. circuit also supply to A.C. circuit containing
Capacitance only
Inductance only
Resistance only
All above

⇒ Inductance affects the direct current flow
Only at the time of turning off
Only at the time of turning on
At the time of turning on and off
At all the time of operation

⇒ The safest value of current the human body can carry for more than 3 second is
4 mA
9 mA
15 mA
25 mA

⇒ A network is said to be non-linear if it does not satisfy
Homogeneity condition
Superposition condition
Both (A) and (B)
Associative condition

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to
2 I
I/2
3/4 I
5/8 I

⇒ In an A.C. circuit power is dissipated in
Resistance only
Inductance only
Capacitance only
None of the above

⇒ In a circuit containing R, L and C, power loss can take place
C only
L only
R only
All of the above

⇒ If resistance is 20 ω and inductance is 2H in a RL series circuit, then time constant of this circuit will be
0.001 S
0.1 S
10 S
100 S

⇒ The series element of a band stop filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C

⇒ The unit of frequency of an A.C. signal is
Cycle
Cycle-sec
Hertz
Hertz/sec

⇒ Form factor is the ratio of
Average value/r.m.s. value
Average value/peak value
r.m.s. value/average value
r.m.s. value/peak value

⇒ For 200 V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
282 V
346 V

⇒ A sine wave of voltage varies from zero to maximum of 200 V. How much is the voltage at the instant of 30° of the cycle ?
50V
82.8V
100V
173.2 V

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.
Impedance
Susceptance
Quality factor
Selectivity

⇒ The best place to install a capacitor is
Very near to inductive load
Across the terminals of the inductive load
Far away from the inductive load
Any where

⇒ The capacitors for power factor correction are rated in terms of
Voltage
VA
kW
kVAR

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is
Apparent power
True power
Reactive power
None of the above

⇒ For the same peak value of voltage which wave form will have the least r.m.s. value ?
Sine wave
Square wave
Triangular wave
Full wave rectified sine wave

⇒ The product of apparent power and cosine of the phase angle between circuit voltage and current is
True power
Reactive power
Volt-amperes
Instantaneous power

⇒ The power factor of a series R-L-C circuit at its half-power points is
Unity
Lagging
Leading
Lagging or leading

⇒ The ratio of active power to apparent power is known as ____ factor.
Demand
Load
Power
Form

⇒ The power factor at resonance in RLC parallel circuit is
Zero
0.08 Lagging
0.8 Leading
Unity

⇒ Higher the Q of a series circuit
Broader its resonance curve
Narrower its pass band
Greater its band width
Sharper its resonace

⇒ In A.C. circuit the power curve is a sine wave having
Double the frequency of voltage
Same frequency as that of voltage
Half the frequency of the voltage
None of these

⇒ The peak value of a sine wave is 200 V. Its average value is
127.4V
141.4V
282.8V
200 V

⇒ Power factor of an inductive circuit is usually improved by connecting capacitor to it in
Parallel
Series
Either (A) or (B)
None

⇒ Skin effect occurs when a conductor carries current at____ frequencies.
Very low
Low
Medium
High