Question is ⇒ The value of current at resonance in series R-L-C circuit is affected by the value of, Options are ⇒ (A) C, (B) L, (C) R, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The value of current at resonance in series R-L-C circuit is affected by the value of, Options are ⇒ (A) C, (B) L, (C) R, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The value of current at resonance in series R-L-C circuit is affected by the value of
A.	C [Wrong Answer]
B.	L [Wrong Answer]
C.	R [Correct Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ The switching expression corresponding
C D + B C
C ⊙ D
C ⊕ D
CD

⇒ Consider the following statements, regarding an OP AMP:

All types of negative feedback reduce non-linear distortion.
All types of negative feedback reduce the output offset voltage.
Non-inverting (current and voltage) feedback increases the input impedance.
Inverting (current and voltage) feedback decreases input impedance.

Which of the above statements is/are correct?
1 only
2 and 3 only
2 and 4 only
1, 2, 3 and 4

⇒ The simplest standing wave is due to the value of reflection co-efficient is
-1
zero
unity
infinity

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒ The life time of a geosynchronous communication
5
10
20
50

⇒ In the given figure the input is x(t) = A sin ωt. The steady state output y(tA sin (ωt + φ) where φ = tan^-1 |G(jω)|
|G(jω)| A sin [ωt + ∠G(jω)]
|G(jω)| A sin [2ωt + ∠G(jω)]
A G(jω) sin [ωt + ∠G(jω)]

⇒ In 8085, the pins for SID and SOD are
4 and 5 respectively
5 and 4 respectively
3 and 4 respectively
4 and 3 respectively

⇒ In a R-L-C circuit at resonance is
maximum in series resonance and minimum in parallel resonance.
maximum in parallel resonance and minimum in series resonance
minimum in both series and parallel resonances
maximum in both series and parallel resonances.

⇒ A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be
1.38 s
5 s
8.62 s
0.9 s

⇒ Two impedances are connected in series. Three voltmeters are connected, one across each impedance and one across combination. The readings of all the three are equal. The phase angle between voltages across the two impedances is
30°
60°
90°
120°

⇒ A string variable in Basic is
an alphabet followed by dollar sign
a digit followed by dollar sign
either (a) or (b)
neither (a) nor (b)

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ Typical value of reverse current in a semiconductor diode is
0.0416666666666667
0.1 A
1 μA
0.1 μA

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ In the full adder, denoting Sum by S and carry by C
S = 1 when two or more inputs are unity
C = 1 when two or more inputs are unity
C = 1 when all the inputs are unity
S = 1 when all the inputs are unity

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be
200
40
4.878
1.212

⇒ μ₀ = 8.85 x 10^-12F/m.
TRUE
FALSE

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒
Assertion (A): As per Miller theorem a capacitance C from input to output appears as a much larger capacitance across input terminals
Reason (R): In a lag network the output voltage appears across capacitor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A mP contains 2 MHz crystal. The time taken to complete instructions with 1000 cycles is
2 ms
1 ms
2 nx
1 ns

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc
0
1 rad/sec
4 rad/sec
16 rad/sec

⇒
Assertion (A): The wave shown in the given figure does not contain the dc component and even harmo
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Consider the following advantages of phase array radar
simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning
Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only

⇒
Assertion (A): Silicon is the most favoured semiconductor material.
Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math