Question is ⇒ The value of 2<sup>5</sup> in octal system is, Options are ⇒ (A) 40, (B) 20, (C) 100, (D) 200, (E) , Leave your comments or Download question paper.

Question is ⇒ The value of 2<sup>5</sup> in octal system is, Options are ⇒ (A) 40, (B) 20, (C) 100, (D) 200, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The value of 2⁵ in octal system is
A.	40 [Correct Answer]
B.	20 [Wrong Answer]
C.	100 [Wrong Answer]
D.	200 [Wrong Answer]
View Answer 4 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode

⇒ Which one of the following rules determines the mapping of s-plane to z-plane?
Right half of the s-plane maps into outside of the unit circle in z-plane
Left half of the s-plane maps into outside of the unit circle.
Imaginary axis in s-plane maps in to the circumference of the unit circle.
All of the above

⇒

Match the following:

	List I (Command in WORD)		List II (Meaning)
A.	END	1.	The bar displays the current position of cursor
B.	HOME	2.	Moves cursor to the beginning of current line
C.	Status	3.	Moves cursor to end of document

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-3, C-1
A-3, B-2, C-1

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ A voltage DAC is generally slower than current DAC
because of more accuracy
because of higher resolution
because of response time of op-amp current to voltage converter
none of the above

⇒ The phenomenon of overlap in converter operation due to
source resistance
source inductance
both source resistance and source inductance
high value of firing angle

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ For a system to be designated as hi-fi, the signal to noise ratio should be at least
25 dB
50 dB
75 dB
100 dB

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ As wavelength decrease the size of high directivity antenna
decreases
increases
is not affected
either (b) or (c)

⇒ Choose the correct statement/statements :
In case of an antenna, the antenna resistance and loss resistance are not two different quantities.
The loss resistance includes loss by eddy currents, improper earth connections, insulation leakages, etc., but not I²R losses.
Radiation resistance varies directly as square-root of frequency
None

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will
be 0
be 1
show no change
toggle

⇒ A lossless transmission line is 50 cm long and operates at a frequency of 500 MHz. Inductance and capacitances present in a line are 0.5 μH/m and 200 pF/m. Phase constant and phase velocity are respectively.
5p, 2p x 10⁸ m/sec
5p, 10⁸ m/sec
31.4, 10⁸ m/sec
31.4, 2p x 10⁸ m/sec

⇒ What is the result for expression (map metho
A + D + BC
A + D
A D + B C
A + D + BC

⇒ 84₁₆ - 2A₁₆ is equal to
5A₁₆
4A₁₆
7A₁₆
15A₁₆

⇒ Telecine equipment in a TV studio consists of
projector telecine
flying spot telecine
digital CCD telecine
none of the above

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ In a 3 phase semiconverter, the dc output voltage for a certain firing angle is 50% of the maximum possible value. The firing angle is
30°
60°
90°
120°

⇒ To bypass a 100 ohm emitter resistor at
10 μF
100 μF
1000 μF
1 μF

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒

Assertion (A): The exponential form of Fourierserie
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an op-amp differentiator
the amplitude of output is proportional to rate of change of input
the amplitude of output is proportional to input
output occurs when input is finite and constant
polarity of input and output is the same

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ A D.C. amplifier amplify
D.C. only
A.C. only
both A.C. and D.C.
none of the above.

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒

Match the following:

	List I (Types of memory)		List II (Used As)
A.	DRAM	1.	Cache memory
B.	SRAM	2.	Main memory
C.	Parallel Access Registers	3.	BIOS memory
D.	ROM	4.	CPU registers

A-1, B-4, C-2, D-3
A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1