Question is ⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be, Options are ⇒ (A) 30 and 24 MHz, (B) 27.3 and 26.7 MHz, (C) 27.3 and 26.97 MHz, (D) 27.3 and 26.97 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be, Options are ⇒ (A) 30 and 24 MHz, (B) 27.3 and 26.7 MHz, (C) 27.3 and 26.97 MHz, (D) 27.3 and 26.97 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
A.	30 and 24 MHz [Wrong Answer]
B.	27.3 and 26.7 MHz [Correct Answer]
C.	27.3 and 26.97 MHz [Wrong Answer]
D.	27.3 and 26.97 MHz [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒

Assertion (A): A GTO can be turned on and turned off by gate pulses

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The knee voltages in silicon and germanium diodes respectively are
0.3 V and 0.7 V
0.7 V and 0.3 V
0.7 V each
0.3 V each

⇒ In a monolithic IC, resistors are formed from
ceramic material
manganin wire
P-type semiconductor
aluminium ribbon

⇒ Which of the following is equivalent to x?
x EX-OR 0
x EX-NOR 0
1 NOR x
x AND x

⇒

Match the following:

	List I (BHE, A0)		List II (Word is read/write)
A.	0, 0	1.	1 byte from/to odd address
B.	0, 1	2.	1 byte from/to even address
C.	1, 0	3.	16 bit word
D.	1, 1	4.	None

A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ A seven bit code (even parity) 1111101 may have error. The correct code is
1111101
1111111
101011
1100011

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒

Match the following:

	List I		List II
A.	TV	1.	1 kHz
B.	Radio	2.	3 kHz
C.	Telephony	3.	9 kHz
D.	Telegraphy	4.	5 MHz

A-4, B-1, C-2
A-4, B-3, C-2
A-2, B-1, C-3
A-1, B-2, C-3

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ In a dynamometer 3 phase power factor meter, the planes of the two moving coils are at
60°
0°
120°
90°

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ At high frequencies the output circuit of transistor amplifier reduces to
a lead network
a lag network
either (a) or (b)
neither (a) nor (b)

⇒ If the resolution of a printer is 1200 dpi, the number of dots per square inch is
1200
800
1200 x 1200
either (a) or (b)

⇒ The voltage in a circuit follows the law v = 100 sin ωt if the frequency is 25 Hz, how long will it take for the voltage to rise to 50 volts?
1/150 s
1/100 s
1/300 s
1/600 s

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ The rms value of wave in figur
about 95 V
about 80 V
about 50 V
about 25 V

⇒ The Z inverse of the given Z transform i
unit step
unit impulse
unit ramp
unit parabola

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ VTM stands for voltage tunable magnetron.
TRUE
FALSE

⇒ Gold is often diffused into silicon P-N junction devices to
increase recombination rate
reduce recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ In which of these is reverse recovery time nearly zero?
Zener diode
Tunnel diode
Schottky diode
PIN diode

⇒ The polarization of dielectric materials results in
production of eddy currents
creation of electric dipoles
absorption of electrons
release of high velocity protons

⇒ Which of the following is not a valid character constant in C?
A'
2'
='
2

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these

⇒ In Z_RC (s) = constant at s = 0, the last element in first Foster cauer realization is
R
C
R and C in series
R and C in parallel