Question is ⇒ The units of μ0 and μr are, Options are ⇒ (A) H/m for both, (B) H/m for μr and no units for μ0, (C) H/m for μ0 and no units for μr, (D) Wb/m for μ0 and no units for μr, (E) , Leave your comments or Download question paper.

Question is ⇒ The units of μ0 and μr are, Options are ⇒ (A) H/m for both, (B) H/m for μr and no units for μ0, (C) H/m for μ0 and no units for μr, (D) Wb/m for μ0 and no units for μr, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The units of μ₀ and μ_r are
A.	H/m for both [Wrong Answer]
B.	H/m for μ_r and no units for μ₀ [Wrong Answer]
C.	H/m for μ₀ and no units for μ_r [Correct Answer]
D.	Wb/m for μ₀ and no units for μ_r [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following produces upper and lower side frequencies?
Microphone
Demodulator in a superheterodyne receiver
Modulator in a. radio transmitter
Oscillator in a receiver

⇒ D/A converters are generally
weighted resistor network
binary ladder network
either (a) or (b)
neither (a) nor (b)

⇒ A coil is wound having a diameter d. Its inductance is 10 mH. If it is rewound on the same core with a wire having diameter 0.5 d and total weight of the wire is the same as before, the inductance will be
5 mH
10 mH
160 mH
40 mH

⇒ The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about
1200 Ω
120 Ω
600 Ω
10 Ω

⇒

Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Space wave may be a direct wave or wave reflected from earth.
TRUE
FALSE

⇒ If transmitted power is 10 kW, the field strength at a distance d is 50 mV/m. If transmitted power is reduced to 2.5 kW, the field strength at the same point will be
25 mV/m
12.5 mV/m
6.25 mV/m
3.125 mV/m

⇒ Calculate i(t) for t ≥ 0, assuming the switch has been in position A for a long time at t = 0, the switch is moved to positio
1 + e^{-5 x 10³t}
e^{-5 x 10³t}
1.11 e^{-5 x 10³t}
1.11 (1 - e^{-5 x 10³t})

⇒ The Boolean expression A ⊕ B is equivalent to
AB + AB
AB + AB
B
A

⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above

⇒ The device most likely to be found in an SSB transmitter is
class C audio amplifier
tuned modulator
class B RF amplifier
class A RF amplifier

⇒ Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
30, 60 and 70 kHz
3, 6 and 7 kHz
30, 60 and 70 MHz
3, 6 and 7 GHz

⇒ For a push pull circuit the most favoured biasing method is
self bias
emitter bias
diode bias
collector bias

⇒ The resistance of a 230 V, 100 W lamp is
529 Ω
2300 Ω
5290 Ω
23 Ω

⇒ A junction FET, can be used as a voltage variable resistor
at pinch-off condition
beyond pinch-off voltage
well below pinch-off condition
for any value of V_DS

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ (9)₁₁ x (9)₁₃ x(9)₁₅ = (?)₁₆
933
2D9
339
9AB

⇒ Directivity of antenna is defined as
maximum directive gain
average directive gain
∞
0

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ The disadvantage of counter type ADC as compared to comparator ADC is that
resolution is low
conversion time is more
circuit is more complex
stability is low

⇒ Which of the following devices is used in the microprocessors?
JFET
BJT
MOSFET
CMOS

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒

Assertion (A): Microprocessors 8086 and 8088 are very similar in organisation and have identical instruction sets.

Reason (R): If clock speed is same the execution time of 8088 and 8086 are exactly equal.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The number of flags available in 6800 are
6
5
7
4

⇒ A two branch parallel tuned circuits has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. The bandwidth is 200 radians/sec. A load of resistance R_L is connected in parallel. The new bandwidth will be
200 rad/sec
more than 200 rad/sec
less than 200 rad/sec
200 rad/sec or less

⇒ A transmission line has Z₀ = 300 Ω and Z_L = (300 - j300) ohm. The transmission coefficient is
1.265 ∠ - 18.43°
1.01 ∠ - 10°
1.14 ∠ 66.68°
1.09 ∠ 66.68°

⇒ There are four different algorithms A1, A2, A3 and A4 to solve, a given problem with the complexity order log(n), log(log(n)), n log and n/log(n) respectively. Which is the best algorithm?
A1
A2
A3
A4

⇒ Which of the following conversion is incorrect?
111110111₂ = 767₈
11011010₃ = 665₈
1011.1111₂ = 13.74₈
10101.11₂ = 26.5₈

⇒ An AM wave is given by s(t)_AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is
0.5
0.58
0.3
0.8

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse