Question is ⇒ The type of noise that interfere very much with high frequency transmission is, Options are ⇒ (A) white, (B) transit time, (C) flicker, (D) shot, (E) , Leave your comments or Download question paper.

Question is ⇒ The type of noise that interfere very much with high frequency transmission is, Options are ⇒ (A) white, (B) transit time, (C) flicker, (D) shot, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The type of noise that interfere very much with high frequency transmission is
A.	white [Wrong Answer]
B.	transit time [Correct Answer]
C.	flicker [Wrong Answer]
D.	shot [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ In a specimen of silicon steel, a field strength of 200 A/m causes a flux density of 0.5 T. In a specimen of cast iron, the same H would cause B to be
0.5 T
less than 0.5 T
more than 0.5 T
0.5 T or more or less

⇒ A circuit said to be lumped when physical dimensions of all the component are __________ .
greater compared with wavelength of electromagnetic signal
small compared with wavelength electromagnetic signal
negligible compared with wavelength of electromagnetic signal
equal compared with wavelength of electromagnetic signal

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000

⇒ A vertical loop antenna, like a horizontal dipole, is vertically polarised.
TRUE
FALSE

⇒ Which of the following conditional statements is not valid in Pascal?
If A > = B then B : = C + D + X
If (N = 45) THEN X : = X + 2 ELSEX : = 0
If A < = B then A : = C * D
If (A > = B) X : Y else X : = Z

⇒ In the given figure,
(A + B)C + DE
AB + C(D + E)
(A + B)C + D + E
none of the above

⇒ In Pascal if I = 45, I div 10 * 10 =
45
40
0.45
0.4

⇒ Which of the following factor does NOT contribute to the drift of a geostationary satellite from its stationary position in space?
Pressure of solar radiations
Gravitational changes due to Sun and Moon
Oblateness of the Earth
Weight of the satellite

⇒ Measurement of an unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when
the primary circuit battery is changed
standardization has to be done again to compensate for drifts
voltage is larger than range of the potentiometer
range reduction by a factor of 10 is employed

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
-180
-120
-90
-60

⇒ In figure, V_C is approximately equa
2 V
4.6 V
8 V
7.6 V

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ Find 'X' in the circuit bel
p(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ Negative feedback lowers the cut off frequency and increase the upper cut off frequency of amplifier.
TRUE
FALSE

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ DeMorgan's first theorem shows the equivalence of
OR gate and Exclusive OR gate
NOR gate and Bubbled AND gate
NOR gate and NAND gate
NAND gate and NOT gate

⇒ Industrial noise has the frequency range of
1 to 100 Hz
200 to 5000 Hz
above 200 MHz
1 to 600 MHz

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ In microwave communication links, when fading due to rain attenuation occurs then technique adopted for solving the problem would include
antenna replacement and feed correction
amplitude timing and phase correction
polarization shifting and code diversity
path diversity and frequency diversity

⇒

Assertion (A): In computers the data is stored in hexadecimal form

Reason (R): Hexadecimal representation is short as compared to binary representation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
Frequency Division Multiple Access (FDMA)
Time Division Multiple Access (TDMA)
Code Division Multiple Access (CDMA)
All of the above

⇒ The frequency deviation of a FM signal produced from PM is
identical to that of FM signal produced by direct method
larger than that of a FM signal produced by direct method
directly proportional to the peak amplitude and the frequency of modulating signal
directly proportional to the peak amplitude of the modulating signal

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ The main drawbacks of EEPROM are
low density
high cost
both low density and high cost
none of the above