Question is ⇒ The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is, Options are ⇒ (A) 100000111, (B) 111, (C) 11111001, (D) 111111001, (E) , Leave your comments or Download question paper.

Question is ⇒ The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is, Options are ⇒ (A) 100000111, (B) 111, (C) 11111001, (D) 111111001, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is
A.	100000111 [Wrong Answer]
B.	111 [Wrong Answer]
C.	11111001 [Correct Answer]
D.	111111001 [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ The selectivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ Typical value of power consumption of TV transmitter is
0.5 kVA
2 kVA
50 kVA
1000 kVA

⇒ The opposition of an inductor to current flow
depends only on the resistance of the coil
depends on the magnitude of the applied voltage
varies directly with frequency
varies inversely with frequency

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ A rectangular wave guide is designed to propagate at the dominant mode TE₁₀ at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height is 2. The dimensions of the guide are
3.75 cm, 1.875 cm
4 cm, 2 cm
8 cm, 4 cm
2.54 cm, 1.27 cm

⇒ Two phasors having rms values V₁ and V₂ which are added to give a phasor having rms value V₃. V₃ is maximum if phase angle between V₁ and V₂ is
90°
180°
270°
360°

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V

⇒ Which group of instructions is used to change sequence of operations in a computer program?
Data transfer group
Branch group
Arithmetic group
Logic group

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ When a lead acid cell is in fully charged condition the positive and negative plates are similar.
TRUE
FALSE

⇒ Companding is used
to overcome quantising noise in PCM
in PWM receivers to reduce impulse noise
to protect small signals in PCM from quantising noise
none of the above

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒ For a npn BJT transistor f_β is 1.64 x 10⁸ Hz. C_μ = 10^-14 F; C_p = 4 x 10^-13 F and DC current gain is 90. Find f_T and g_m (f_β = cut off frequency, C_μ = capacitance, C_p = parasitic capacitance, g_m = transconductance, f_T = gain BW product)
f_T = 1.47 x 10¹⁰ Hz ; g_m = 38 milli mho
f_T = 1.64 x 10⁸ Hz ; g_m = 30 milli mho
f_T = 1.47 x 10⁹ Hz ; g_m = 38 mho
f_T = 1.33 x 10¹² Hz; g_m = 0.37 m-mho

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ An amplifier with resistive -ve feedback has two left poles in its open loop transfer function. The amplifier
will always be unstable at high frequencies
will be stable for all frequencies
may be unstable, depending on the feedback factor
will oscillate at low frequencies

⇒ In microwave communication, some times, microwave signals reach large distances by following the earth curvature. This phenomenon is called
tropospheric scatter
faraday effect
ionospheric reflection
ducting

⇒ Consider the following stateme
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒

Assertion (A): CMOS devices have very high speed.

Reason (R): CMOS devices have very small physical size and simple geometry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ In a triode the potential of grid (with respect to cathode) is usually
zero
negative
positive
zero or positive

⇒ Octal 16 is equal to decimal
13
14
15
16

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ A permeable substance is one
which is strong magnet
which is a weak magnet
which is a good conductor
through which magnetic lines of force can pass easily

⇒ The units of transistor h parameters h₁₁ and h₂₂ are the same.
TRUE
FALSE