Question is ⇒ The transient currents are associated with the, Options are ⇒ (A) Changes in the stored energy in the inductors and capacitors, (B) Impedance of the current, (C) Applied voltage to the circuit, (D) Resistance of the circuit, (E) , Leave your comments or Download question paper.

Question is ⇒ The transient currents are associated with the, Options are ⇒ (A) Changes in the stored energy in the inductors and capacitors, (B) Impedance of the current, (C) Applied voltage to the circuit, (D) Resistance of the circuit, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The transient currents are associated with the
A.	Changes in the stored energy in the inductors and capacitors [Correct Answer]
B.	Impedance of the current [Wrong Answer]
C.	Applied voltage to the circuit [Wrong Answer]
D.	Resistance of the circuit [Wrong Answer]
View Answer 8 -7 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The ratio of active power to apparent power is known as ____ factor.
Demand
Load
Power
Form

⇒ The value of operator j2 is equal to
Zero
+1
-1
√-1

⇒ Which of the following circuit component opposes the change in the circuit voltage
Inductance
Capacitance
Conductance
Resistance

⇒ Form factor is the ratio of
Average value/r.m.s. value
Average value/peak value
r.m.s. value/average value
r.m.s. value/peak value

⇒ A coil with large distributed capacitance has a
High resonant frequency
Low resonant frequency
Low quality factor
Low resistance

⇒ The unit of frequency of an A.C. signal is
Cycle
Cycle-sec
Hertz
Hertz/sec

⇒ For a sine wave with peak value I_max the r.m.s. value is
0.5 I_max
0.707 I_max
0.9 I_max
1.414 I_max

⇒ At half power points of a resonance curve, the current is____ times the maximum current.
1/2
1/ √2
√2
2

⇒ The power is measured in terms of decibles in case of
Electronic equipment
Transformers
Current transformers
Auto-transformers

⇒ Power factor of the following circuit will be unity
Inductance
Capacitance
Resistance
Both (A) and (B)

⇒ At____ frequencies the parallel R-L circuit behaves as purely resistive.
Low
Very low
High
Very high

⇒ In A.C. circuit laminated iron is invariably used in order to
Reduce eddy current loss
Increase heat radiation
Make assembly cheap and easier
Reduce circuit permeability

⇒ The dual of a loop is
Twig
Node pair
Mesh
Tree

⇒ A sine wave of voltage varies from zero to maximum of 200 V. How much is the voltage at the instant of 30° of the cycle ?
50V
82.8V
100V
173.2 V

⇒ In a circuit containing R, L and C, power loss can take place
C only
L only
R only
All of the above

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?
Square wave
Half wave rectified sine wave
Triangular wave
Sine wave

⇒ In an A.C. circuit I sin Φ is called
Active component
Wattless component
Any of the above
None of these

⇒ Two waves of the same frequency have opposite phase when the phase angle between them is
360°
180°
90°
0°

⇒ For the full wave rectified sine wave the r.m.s. value is
0.707 I_max
0.636 I_max
0.318 I_max
Zero

⇒ The safest value of current the human body can carry for more than 3 second is
4 mA
9 mA
15 mA
25 mA

⇒ A resonance curve for a series circuit is a plot of frequency versus
Current
Voltage
Impedance
Reactance

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒ Inductance affects the direct current flow
Only at the time of turning off
Only at the time of turning on
At the time of turning on and off
At all the time of operation

⇒ For a sine wave with peak value E_max the average value is
0.636 E_max
0.707 E_max
0.434 E_max
1.414 E_max

⇒ In the R - L - C containing R = 4.5ω L = 0.06 H,C = 0.6 µF the power factor will be
Zero
Lagging
Leading
Unity

⇒ Ohm is the unit of all of the following except
Inductive reactance
Capacitive reactance
Resistance
Capacitance

⇒ A parallel resonant circuit can be used
As a high impedance
To reject a small band of frequencies
Both (A) and (B)
To amplify certain frequencies

⇒ The power factor of incandescent bulb is
0.8 lagging
0.8 leading
Unity
Zero

⇒ Higher the Q of a series circuit
Broader its resonance curve
Narrower its pass band
Greater its band width
Sharper its resonace

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave