Question is ⇒ The transfer function of transportation lag is, Options are ⇒ (A) G(jω) = ejωT , (B) G(jω) = e-jωT , (C) G(jω) = (1 + jωT), (D) G(jω) = (1 - jωT), (E) , Leave your comments or Download question paper.

Question is ⇒ The transfer function of transportation lag is, Options are ⇒ (A) G(jω) = ejωT , (B) G(jω) = e-jωT , (C) G(jω) = (1 + jωT), (D) G(jω) = (1 - jωT), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The transfer function of transportation lag is
A.	G(jω) = e^jωT [Wrong Answer]
B.	G(jω) = e^-jωT [Correct Answer]
C.	G(jω) = (1 + jωT) [Wrong Answer]
D.	G(jω) = (1 - jωT) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In case of antenna the ratio of the power radiated in the desired direction to the power radiated in the opposite direction is known as
transmission efficiency
front to back ratio
loss coefficient
none of the above

⇒ The signals in 8086 are in maximum mode when
MN / MX pin is tied to V_cc
MN / MX Pin is grounded
MN / Mx pin is left open
none of the above

⇒ For the system with given characteristic equat
3, 2, 0
4, 0, 1
3, 0, 2
4, 1, 0

⇒ The range of memory location in given memory interfacing scheme
0000H - 07FFH
F800H - FFFFH
0000H - 03FFH
0000H - 3FFFH

⇒ The amount of time between the creation and recombination of a free electron and hole is called
relaxation time
life time
lorentz time
collision time

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ A capacitor stores 0.15C at 5 V. Its capacitance is
0.75 F
0.75 μF
0.03 F
0.03 μF

⇒ The device most likely to be found in an SSB transmitter is
class C audio amplifier
tuned modulator
class B RF amplifier
class A RF amplifier

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ Registers and counters are similar in the sense that they both
count pulses
store binary information
are made from an array of flip-flops and gates integrated on a single chip
are shift registers

⇒ Which op-amp circuit uses a capacitor in series with input and resistance in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
None of the above

⇒ The HV supply to a TV receiver is 25 kV and the total beam current for the three electron guns is 2000 μA. The power handled by IHVT is
5W
0.5 W
50 W
500 W

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Measurement of hall coefficient enables the determination of
mobility of charge carriers
type of conductivity and concentration of charge carriers
temperature coefficient and concentration of charge carriers
fermi level and forbidden energy gap

⇒ Industrial noise has the frequency range of
1 to 100 Hz
200 to 5000 Hz
above 200 MHz
1 to 600 MHz

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ The maximum forward current in case of signal diode is in the range of
1 A to 10 A
0.1 A to 1 A
few milli amperes
few nano amperes

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ A circular polarizer converts a linearly polarized wave into a circularly polarised wave.
TRUE
FALSE

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ Whereas resonant antenna is bidirectional, non-resonant antenna is unidirectional.
TRUE
FALSE

⇒ In which n type device does p substrate extend upto silicon dioxide layer?
JFET
Depletion type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ For type 2 system, the magnitude and phase angle of the term (jω)² in the denominator, at ω = 0, are respectively
0 and - 90°
0 and + 90°
infinity and - 180°
infinity and + 180°