Question is ⇒ The transfer function of a discrete time LTI system is give, Options are ⇒ (A) Both S1 and S2 are true, (B) Both S2 and S3 are true, (C) Both S1 and S3 are true, (D) S1, S2 and S3 are all true, (E) , Leave your comments or Download question paper.

Question is ⇒ The transfer function of a discrete time LTI system is give, Options are ⇒ (A) Both S1 and S2 are true, (B) Both S2 and S3 are true, (C) Both S1 and S3 are true, (D) S1, S2 and S3 are all true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The transfer function of a discrete time LTI system is give
A.	Both S1 and S2 are true [Wrong Answer]
B.	Both S2 and S3 are true [Wrong Answer]
C.	Both S1 and S3 are true [Correct Answer]
D.	S1, S2 and S3 are all true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The phase angle of a lag circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets

⇒ In the given figure the input frequency is such that R << X_c,
v₀ lags v_i by 90°
v₀ leads v_i by 90°
v₀ and v_i are in phase
either (b) or (c)

⇒ Macroscopic quantities of a given material
are absolutely constant
are a function of temperature
are a function of temperature, pressure field
none of the above

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ The dimensions of EMF are
ML²I^-1T^-3
M^-1T^-3
ML²I^-2T^-3
ML³I^-1T^-3

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ The op-amp used in nonlinear mode is
integrators
active filters
Schmitt triggers
instrumentation amplifiers

⇒ A lossless 50 Ω transmission line is terminated 30 + j25 Ω, then voltage reflection coefficient and current reflection coefficient are
062 ∠82.88, - 0.62 ∠82.88
10.36 ∠11.296, - 10.36 ∠111.296
0.23 ∠49.1, - 0.23 ∠ + 49.1
- 10.36 ∠111.296, 10.36 ∠111.296

⇒ The current in an RL series circuit is 1 - e^-t amperes. Then di/dt is
1 - e^-t
- e^-t
e^t
e^-2t

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ In a 7 segment display, LEDs b and c lit up. The decimal number displayed is
9
7
3
1

⇒ In a feedback series regular circuit, the output voltage is regulated by controlling the
magnitude of the I/P voltage
gain of the feed back BJT
reference Voltage
voltage drop across the series pass transistor

⇒ With respect to the differential amplifier configuration shown below, the differential gain A_d will
273.63
213.63
113.63
233.63

⇒ The symbol in figure is
UJT
PUT
SCS
SBS

⇒ In figure, power in 6 Ω resistor is zero then
202∠45°
20 ∠30°
20 ∠45°
202∠30°

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒

Assertion (A): The regular or irregular stacking of atoms has importanteffect on properties of materials.

Reason (R): The arrangement of atoms in a given material can be studied using X-rays.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In gases the flow of current is due to
positive ions only
electrons only
electrons, positive ions and negative ions
electrons and positive ions

⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
0.6
0.25
4
0.36

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒

Assertion (A): An SR latch has the problem of RAC condition

Reason (R): While designing a digital circuit RAC condition should be avoided.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Carbon resistances are used in very high values.
TRUE
FALSE

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ Radio broadcasting is a familiar example of
space multiplexing
time multiplexing
frequency multiplexing
none of the above

⇒ A counter displays a sequence of numbers. If a reading corresponds to the hexadecimal number F52E, the next two readings are respectively
F52F, F520
F530, F531
F52F, F530
F52F, F52G

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒ When a line of any odd multiple of a quarter wavelength is short-circuited it represents
unit impedance
infinite impedance
zero impedance
none of the above