Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
The total number of leads in SUS, SBS and SCS respectively are | |
A. | 3, 3, 4, [Correct Answer] |
B. | 3, 3, 3 [Wrong Answer] |
C. | 2, 3, 3 [Wrong Answer] |
D. | 3, 3, 5 [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ In a zener diode
the forward current is very high
sharp breakdown occurs at a certain reverse voltage
the ratio v-i can be negative
there are two p-n junctions
⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A
⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD
⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed
⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier
⇒ In the DRAM cell in the figure is the V_{t} of the NMOSFET is 1 V. For the following three combinations of WL and BL volta
5 V, 3 V, 7 V
4 V, 3 V, 4 V
5 V, 5 V, 5 V
4 V, 4 V, 4 V
⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has directivity of 100 is
15.92
31.84
2.18
3.184
⇒ Consider the following Statements regarding resistance strain gauge
1, 2, 3
1 and 2
2 and 3
1 and 3
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true
⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above
⇒ The rotation of direction of E field of a linearly polarized wave passing through a magnetised ferric medium is called
Lorentz rotation
Faraday rotation
Steinmitz rotation
Fleming's rotation
⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage
⇒ The advantage of LVDT over inductive bridge type transducer is that
it gives high output for small changes in core position
it can be used over a temperature range of - 265°C to 600°C
it can measure displacement of moving object
the error due to stray magnetic field is less
⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32
⇒ The parameter A of a two port network is equal to
V_{2}/V_{1} with I_{1} = 0
V_{1}/I_{2} with V_{2} = 0
I_{1}/I_{2} with V_{2} = 0
V_{1}/V_{2} with I_{2} = 0
⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies
⇒ If a function Z(s) has a pole at infinity, then
the degrees of numerator and denominator are equal
the degree of numerator is one higher than that of denominator
the degree of denominator is one higher than that of numerator
the difference between the degrees of numerator and denominator is 0 or 1
⇒ In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
zener current is very small
zener current is very large
zener current is neither small nor large
None of the above
⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be1.5708
1
28.2744
18
⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A
⇒ The transfer function of a system is given by H(s) = 1/s^{2} (s - 2). The impulse response of the system is
(t^{2*} e^{-2t}) U(t)
(t^{*} e^{2t}) U(t)
(te^{-2t}) U(t)
(te^{2t}) U(t)
⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple
⇒ For the network of figure, z_{115/3 Ω3/2 Ω2 Ω2/3 Ω}
⇒ A folded dipole antenna is conveniently connected to
shielded line
two wire line
coaxial line
flat ribbon type transmission line
⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases
⇒ In a JFET
the source gate junction is forward biased and gate drain junction is reverse biased
both the junctions are forward biased
both the junctions are reverse biased
the source gate junction is reverse biased and gate drain junction is forward biased
⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg
⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola
⇒ Find the odd one out
sweep voltage generator
multivibrators
sine wave oscillators
blocking oscillators
⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above
⇒ In a zener diode
the forward current is very high
sharp breakdown occurs at a certain reverse voltage
the ratio v-i can be negative
there are two p-n junctions
⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A
⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD
⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed
⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier
⇒ In the DRAM cell in the figure is the V_{t} of the NMOSFET is 1 V. For the following three combinations of WL and BL volta
5 V, 3 V, 7 V
4 V, 3 V, 4 V
5 V, 5 V, 5 V
4 V, 4 V, 4 V
⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has directivity of 100 is
15.92
31.84
2.18
3.184
⇒ Consider the following Statements regarding resistance strain gauge
- The gauge factor is in the range of 2 to 5.
- The resistance changes due to change in specific resistance with strain.
- The resistance increases with increase in temperature.
1, 2, 3
1 and 2
2 and 3
1 and 3
⇒
Assertion (A): In state space analysis, capacitors are taken to be in tree.
Reason (R): State variable analysis is very suitable for computer solution.
Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true
⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above
⇒ The rotation of direction of E field of a linearly polarized wave passing through a magnetised ferric medium is called
Lorentz rotation
Faraday rotation
Steinmitz rotation
Fleming's rotation
⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage
⇒ The advantage of LVDT over inductive bridge type transducer is that
it gives high output for small changes in core position
it can be used over a temperature range of - 265°C to 600°C
it can measure displacement of moving object
the error due to stray magnetic field is less
⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32
⇒ The parameter A of a two port network is equal to
V_{2}/V_{1} with I_{1} = 0
V_{1}/I_{2} with V_{2} = 0
I_{1}/I_{2} with V_{2} = 0
V_{1}/V_{2} with I_{2} = 0
⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies
⇒ If a function Z(s) has a pole at infinity, then
the degrees of numerator and denominator are equal
the degree of numerator is one higher than that of denominator
the degree of denominator is one higher than that of numerator
the difference between the degrees of numerator and denominator is 0 or 1
⇒ In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
zener current is very small
zener current is very large
zener current is neither small nor large
None of the above
⇒ If RADIUS = 3.0 the result of the following FORTRAN 77 program will be
1
28.2744
18
⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A
⇒ The transfer function of a system is given by H(s) = 1/s^{2} (s - 2). The impulse response of the system is
(t^{2*} e^{-2t}) U(t)
(t^{*} e^{2t}) U(t)
(te^{-2t}) U(t)
(te^{2t}) U(t)
⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple
⇒ For the network of figure, z_{115/3 Ω3/2 Ω2 Ω2/3 Ω}
⇒ A folded dipole antenna is conveniently connected to
shielded line
two wire line
coaxial line
flat ribbon type transmission line
⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases
⇒ In a JFET
the source gate junction is forward biased and gate drain junction is reverse biased
both the junctions are forward biased
both the junctions are reverse biased
the source gate junction is reverse biased and gate drain junction is forward biased
⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg
⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola
⇒ Find the odd one out
sweep voltage generator
multivibrators
sine wave oscillators
blocking oscillators
⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above