Question is ⇒ The time period of a sine wave is 1/50 seconds. Its frequency is, Options are ⇒ (A) 20 Hz, (B) 30 Hz, (C) 40 Hz, (D) 50 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ The time period of a sine wave is 1/50 seconds. Its frequency is, Options are ⇒ (A) 20 Hz, (B) 30 Hz, (C) 40 Hz, (D) 50 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The time period of a sine wave is 1/50 seconds. Its frequency is
A.	20 Hz [Wrong Answer]
B.	30 Hz [Wrong Answer]
C.	40 Hz [Wrong Answer]
D.	50 Hz [Correct Answer]
View Answer 72 -47 Explanation:- Answer : D Discuss it below : Chittaranjan Said on 2017-05-30 04:47:10 F=1/T Arundeep Said on 2017-04-19 19:49:37 In short Time T and Frequency F are inversely proportional Sajjad Said on 2017-02-17 19:43:49 T=1/f so f=1/t SAMIR Said on 2016-12-08 09:11:59 Yes f=1/T Vishnu Said on 2016-07-18 09:17:59 tq u rahul and seema Rahul Said on 2015-11-14 03:11:25 F=1/T Seema Said on 2015-07-26 19:27:47 t=1/f so f=t/1 means f=t !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The double energy transient occur in the
Purely inductive circuit
R-L circuit
R-C circuit
R-L-C circuit

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave

⇒ The ratio of active power to apparent power is known as ____ factor.
Demand
Load
Power
Form

⇒ At very low frequencies a series R-C circuit behaves as almost purely____
Resistive
Inductive
Capacitive
None of these

⇒ The transient currents are associated with the
Changes in the stored energy in the inductors and capacitors
Impedance of the current
Applied voltage to the circuit
Resistance of the circuit

⇒ Poor power factor results in all of the following EXCEPT.
Overloading of transformers
Overloading of altemators
Reduction in power losses
Reduction in load handling capacity of electrical system

⇒ The power taken by a 3-Φ load is given by the expression
√3 V_L I_L sinΦ
√3 V_L I_L cosΦ
3 V_L I_L sinΦ
3 V_L I_L cosΦ

⇒ The product of apparent power and cosine of the phase angle between circuit voltage and current is
True power
Reactive power
Volt-amperes
Instantaneous power

⇒ Which of the following circuit component opposes the change in the circuit voltage
Inductance
Capacitance
Conductance
Resistance

⇒ For the full wave rectified sine wave the r.m.s. value is
0.707 I_max
0.636 I_max
0.318 I_max
Zero

⇒ While drawing vector diagram for a series circuit the reference vector is
Voltage
Current
Power
Phase angle

⇒ In an A.C. circuit power is dissipated in
Resistance only
Inductance only
Capacitance only
None of the above

⇒ In a circuit containing R, L and C, power loss can take place
C only
L only
R only
All of the above

⇒ The power factor at resonance in RLC parallel circuit is
Zero
0.08 Lagging
0.8 Leading
Unity

⇒ The dual of a link is
Twig
Node
Loop
Tree branch

⇒ The shunt element in a band pass filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C

⇒ The shunt element of prototype high pass filter is
Resistive
Inductive
Capacitive
Combination of L and C

⇒ In the R - L - C containing R = 4.5ω L = 0.06 H,C = 0.6 µF the power factor will be
Zero
Lagging
Leading
Unity

⇒ In a pure resistive circuit
Current lags behind the voltage by 90°
Current leads the voltage by 90°
Current can lead or lag the voltage by 90°
Current is in phase with the voltage

⇒ The r.m.s. value and mean value is the same in the case of
Triangular wave
Sine wave
Square wave
Half wave rectified sine wave

⇒ Power factor of the following circuit will be zero
Resistance
Inductance
Capacitance
Both (B) and (C)

⇒ The negative maximum of a cosine wave occurs at
30
45
90
180

⇒ The unit of frequency of an A.C. signal is
Cycle
Cycle-sec
Hertz
Hertz/sec

⇒ Ohm is the unit of all of the following except
Inductive reactance
Capacitive reactance
Resistance
Capacitance

⇒ Power factor of electric bulb is
Zero
Lagging
Leading
Unity

⇒ Skin effect occurs when a conductor carries current at____ frequencies.
Very low
Low
Medium
High

⇒ The power factor of a series R-L-C circuit at its half-power points is
Unity
Lagging
Leading
Lagging or leading

⇒ Which of the following statement is incorrect ?
Resistance is a passive element
Voltage source is an active element
Conductance is a passive element
Current source is a passive element

⇒ The power consumed in a circuit element will be least when the phase difference between the current and voltage
180°
90°
60°
0°

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is
Apparent power
True power
Reactive power
None of the above