Question is ⇒ The time constant of an R.C. circuit increases if the value of resistance is, Options are ⇒ (A) increased, (B) decreased, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The time constant of an R.C. circuit increases if the value of resistance is, Options are ⇒ (A) increased, (B) decreased, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The time constant of an R.C. circuit increases if the value of resistance is
A.	increased [Correct Answer]
B.	decreased [Wrong Answer]
C.	either of the above [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The thermionic emission current is given by
Fermi-Dirac distribution
Maxwell's equation
Richardson Dushman equation
Langmuir Child law

⇒ An RLC series circuit
resonant frequency is high
Q is high
bandwidth is large
Q is low

⇒ The circuit whose properties are same in either direction is known as
unilateral circuit
bilateral circuit
irreversible circuit
reversible circuit

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small

⇒ A short grounded vertical antenna has a length L which is 0.05λ at frequency f. If its radiation resistance at f is R ohms, then its radiation resistance at a frequency 2f will be
R/2Ω
RΩ
2RΩ
4RΩ

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒

Assertion (A): The unit of telephone traffic measurement is erlang.

Reason (R): International circuits for communication are fitted with echo suppressors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A klystron amplifier generally uses Pierce gun
TRUE
FALSE

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ In the expression b = 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?
2.1 / 1.2
1.2 * 3.1
2.1 / 1.2 * 3.1
3 / 7.1

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒ In figure the coordinates of Q point on the load line are (Neglect V_{BEI_C = 10 mA, V_CE = 15 V
I_C = 5 mA, V_CE = 22.5 V
I_C = 5 mA, V_CE = 15 V
I_C = 10 mA, V_CE = 22.5 V}

⇒ When load is coupled to class A amplifier through transformer, efficiency decreases.
TRUE
FALSE

⇒ An RL admittance function can also be realized as
RC admittance function
RC impedance function
LC admittance function
LC impedance function

⇒ Which of the following output configurations are available in a TTL gate?

Open collector output
Totem pole output
Tristate output

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ The conductivity of an intrinsic semiconductor is (symbols have the usual meanings).
generally less than that a doped semiconductor
σ_i = en_i (μ_n - μ_p)
σ_i = en_i (μ_n + μ_p)
σ_i = n_i (μ_n - μ_p)

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ The feedback control system shown in figure is sta
for all K ≥ 0
only if K ≥ 1
only if 0 ≤ K < 1
only if -1 ≤ K < 1

⇒ The noise figure of individual stages of a two stage amplifier is 2.03 and 1.54 respectively. If gain of first stage is 62, the overall noise figure is
2.03
2.055
3.05
6.05

⇒ A vacant electronic state moves in the same direction as would a positive charge carrier.
TRUE
FALSE

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒

Assertion (A): An impulse has very high magnitude but very small duration.

Reason (R): A pulse function is always rectangular.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The waveform shown in the given Figure can be written
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - 4u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) + 4u(t - 5)

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ One of the major applications of JFET is in
switching
constant current-source
constant voltage-source
electron flow regulation

⇒ Crossover distortion behaviour is characteristic of
class A O/P stage
class B O/P stage
class AB output stage
common pulse O/P state

⇒ A BJT is said to be operating in saturation region if
both junctions are reverse biased
both junctions are forward biased
base emitter junction is forward biased and base collector junction is reverse biased
base collector junction is forward biased and base emitter junction is reverse biased

⇒

Assertion (A): In a conductor, current density remains constant in time as long as E is constant.

Reason (R): In a conductor, J = σE.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A heterodyne frequency changer is called a
Modulator
Mixer
Demodulator
Frequency translator