Question is ⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is, Options are ⇒ (A) more than 100 kHz, (B) equal to 100 kHz, (C) equal to 10 kHz, (D) less than 10 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is, Options are ⇒ (A) more than 100 kHz, (B) equal to 100 kHz, (C) equal to 10 kHz, (D) less than 10 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
A.	more than 100 kHz [Wrong Answer]
B.	equal to 100 kHz [Wrong Answer]
C.	equal to 10 kHz [Correct Answer]
D.	less than 10 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The accuracy of measurement by ohmmeter is very good.
TRUE
FALSE

⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
increase its I_QL
reduce its I_0H
increase its speed of operation
reduce power dissipation

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ The waveform shown in the given Figure can be written
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - 4u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) + 4u(t - 5)

⇒ For a permanent magnetic material
the residual induction and coercive field should be large
the residual induction and coercive field should be small
area of hysteresis loop should be small
initial relative permeability should be high

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒

Assertion (A): Tie set schedule is used in nodal analysis.

Reason (R): Loop currents are fictitious quantities.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The effective electrical length of an antenna is __________ its physical length
greater than
equal to
less than
none of the above

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ Consider the following statements as regards communication receiver

Variable sensitivity is used to eliminate selective fading
A product demodulator can be used to receive Morse code
The noise limiter cuts off receiver output during a noise pulse
Double conversion is used to improve image rejection

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ Ground wave can be used for communication upto
5 kHz
12 kHz
16 kHz
25 kHz

⇒ The Voltage e₀ in the figu
2 V
4 V
4/3 V
8 V

⇒ An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
harmonic distortion
intermodulation distortion
both (a) and (b)
none of the above

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following is multiband HF receiving antenna?
Square loop
Log-periodic
Conical horn
Folded dipole

⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ Some types of traps used in video IF amplifier of colour TV are
shunt traps
series traps
absorption traps
all of the above

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ Secondary emission occurs in
diode
triode
tetrode
pentode

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒

Assertion (A): The polynomial s³ + 6s² + 12s + 8 is Hurwitz.

Reason (R): In a Hurwitz polynomial all coefficients are non-negative.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒ Which of the following is not a travelling wave?
e = E_m sin (βx - ωt)
e = E_m cos (βx - ωt)
e = E_m sin (ωt - βx)
e = E_m sin (βx)

⇒ Which one of the following is correct?
RAM is a volatile memory but ROM is non-volatile memory
RAM is non-volatile memory but ROM is volatile memory
Both ROM and RAM are volatile but in ROM data is not lost when power is switched off
Both ROM and RAM are non-volatile but in RAM data is lost when power is switched off

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}