Question is ⇒ The term critical frequency denotes, Options are ⇒ (A) the lowest frequency that is reflected by the ionosphere, (B) the highest frequency that is reflected by the ionosphere at vertical distance, (C) the lowest frequency by which communication is possible between two given points, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The term critical frequency denotes, Options are ⇒ (A) the lowest frequency that is reflected by the ionosphere, (B) the highest frequency that is reflected by the ionosphere at vertical distance, (C) the lowest frequency by which communication is possible between two given points, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The term critical frequency denotes
A.	the lowest frequency that is reflected by the ionosphere [Wrong Answer]
B.	the highest frequency that is reflected by the ionosphere at vertical distance [Correct Answer]
C.	the lowest frequency by which communication is possible between two given points [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The polynomial s³ + 6s² + 12s + 8 is Hurwitz.

Reason (R): In a Hurwitz polynomial all coefficients are non-negative.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ The 2732 is 4096 x 8 EPROM. How many address lines does it have?
12
24
50
100

⇒ Which statement is true for an ac circuit?
Active power is always less than apparent power
Active power cannot be more than apparent power
Active power is always more than reactive power
Active power cannot be more than reactive power

⇒ In radio receiver, the maximum contribution to noise is from
mixer stage
power supply
power amplifier
equally from above three

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒ A class B chopper operates in third quadrant.
TRUE
FALSE

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ Which of the following features is not associated with Nichols chart?
(0 dB, -180°) point on Nichols chart represent critical Point (-1, 0)
It is symmetric about -180°
M loci are centred about (0 dB, -180°) point
The frequency at intersection of G(jω) locus and M = +3 dB locus gives bandwidth of closed loop system

⇒ A relaxation oscillator uses
tunnel diode
UJT
both tunnel diode and UJT
PIN diode

⇒ Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.
TRUE
FALSE

⇒ AB + AB =
B
A
1
0

⇒ The units of resistivity are ohm-metre.
TRUE
FALSE

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ The minterm designation for ABCD is
m₁₁
m₁₃
m₁₅
m₁₆

⇒ In a digital system there are three inputs ABC. Output should be high when atleast two inputs are high. Then output =
AB + BC + AC
ABC + ABC + A BC + ABC
AB + BC + AC
AB + BC + AC

⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ How many distinct binary trees can be constructed with three nodes?
1
2
3
5

⇒ In a 7 segment display the segments a, c, d, f, g are lit. The decimal number displayed will be
9
5
4
2

⇒ At a very low temperature, a semiconductor
becomes a conductor
becomes an insulator
may become a conductor or an insulator
will remain a semiconductor becomes a conductor or an insulator

⇒ In cell communication
carrier frequency change
carrier frequency constant
depend upon location
depend upon geographical area

⇒ In a conductor the conduction and valence bands overlap
TRUE
FALSE

⇒ The pole-zero plot given below corresponds
low pass filter
high pass filter
band pass filter
notch filter

⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
a, b, d
a, b, c
all
a, b, g, c, d

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ Equipment using BCD numbers
pocket calculators
electronic counter
digital voltmeters
all of the above