Question is ⇒ The term __________ applies to troposcatter propagation, Options are ⇒ (A) fading, (B) Faraday rotation, (C) SIDS, (D) atmospheric storms, (E) , Leave your comments or Download question paper.

Question is ⇒ The term __________ applies to troposcatter propagation, Options are ⇒ (A) fading, (B) Faraday rotation, (C) SIDS, (D) atmospheric storms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The term __________ applies to troposcatter propagation
A.	fading [Wrong Answer]
B.	Faraday rotation [Correct Answer]
C.	SIDS [Wrong Answer]
D.	atmospheric storms [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?
Linear oscillations
Non-linear oscillations
Damped oscillations
No oscillations

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ The logic operation that will selectively clear bits in register A in those positions where these are 1 's in the bits of register B is given by
A ← A + B
A ← AB
A ← A + B
A ← AB

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒

Match the following:

	List I		List II
A.	Synchro	1.	Amplifier
B.	Amplidyne	2.	Actuator
C.	Servo	3.	Compensator
D.	RC network	4.	Transducer

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1
A-4, B-1, C-2, D-3

⇒ In a lag network the input frequency is 100 f_c where f_c is critical frequency. The voltage gain is
0 dB
-20 dB
-40 dB
-60 dB

⇒ In a class C operation V_CC = 40 V and V_CE(sat) = 0.4 V. The efficiency is
0.9
0.495
0.01
0.005

⇒ In spread spectrum technique
a modulated signal is modulated again
a modulated signal is modulated twice again
the power of a modulated signal is increased
the noise component of a modulated signal is decreased

⇒ A computer memory is an ordered sequence of storage cells.
TRUE
FALSE

⇒ Which of following digital modulation technique?
ASK
FSK
PSK
All

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒

Assertion (A): A synchro control transformer has nearly constant impedance across its rotor terminals.

Reason (R): Rotor of a synchro control transformer is cylindrical so as to give uniform flux distribution.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the following statements about instrument landing system of aircraft

It ensures correct landing under conditions of low visibility.
It consists of runaway localizer, glide path equipment and marker beacons.
It is basically a blind landing system.

Which of above statements are correct?
All
1 and 2 only
1 and 3 only
2 only

⇒ The highest modulation frequencies typically used in FM broadcast is
5 kHz
10 kHz
15 kHz
25 kHz

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒ A folded dipole antenna is conveniently connected to
shielded line
two wire line
coaxial line
flat ribbon type transmission line

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒ The maximum permissible distance between two samples of a 2 kHz signal is
1000 μ sec
500 μ sec
250 μ sec
2000 sec

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ The main purpose of using transformer coupling in a class A amplifier is to make it more
efficient
less costly
less bulky
distortion free

⇒ For the two port of figure, z_{2226/7 Ω
6/7 Ω
2/3 Ω
1 Ω}

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is
40 A
20 A
0.416666666666667
0.208333333333333

⇒

Assertion (A): A high junction temperature may destroy a diode.

Reason (R): As temperature increases the reverse saturation current increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	ATTRIB	1.	Displays all directories and subdirectories
B.	SCAN DISK	2.	Moves files to another director
C.	MOVE	3.	Checks the status of disc
D.	TREE	4.	Hides a file

A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

⇒ The directive gain of a transmitting antenna is
proportional to wavelength
inversely proportional to wavelength
proportional to square of wavelength
inversely proportional to square of wavelength

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ Drift velocity of electrons is generally less than 1 mm/s.
TRUE
FALSE

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF