Question is ⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is, Options are ⇒ (A) 0.0042, (B) 0.0035, (C) 0.0025, (D) 0.0015, (E) , Leave your comments or Download question paper.

Question is ⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is, Options are ⇒ (A) 0.0042, (B) 0.0035, (C) 0.0025, (D) 0.0015, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is
A.	0.0042 [Wrong Answer]
B.	0.0035 [Correct Answer]
C.	0.0025 [Wrong Answer]
D.	0.0015 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is
2
10
20
100

⇒ The Lissajous pattern observed on screen of CRO is a straight line inclined at 45° to x axis. If X-plate input is 2 sin ωt, the Y-plate input is
2 sin ωt
2 sin (ωt + 45°)
2 sin (ωt - 45°)
22 sin ωt + 45°)

⇒ In figure v₁ = 8 V and v₂ = 4 V. Which diode will cond
D₂ only
D₁ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ Eddy current loss is
proportional to frequency
independent of frequency
proportional to (frequency)²
proportional to (frequency)³

⇒ When a thyristor is conducting, the voltage drop across it
is absolutely constant
decreases with increase in load current
increases slightly with increase in load current
none of the above

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒ The signal m(t) = 10 cos 100 pt is sampled at the rate of F_s = 75 H_z, then determine signal after sampling.
4 cos 100 pt + 8 sin 200 pt
4 cos 100 pt + 8 sin 200 pt + cos 75 pt
4 cos 25 pt + 8 sin 50 pt + cos 75 pt
none

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ To eliminate ghosts in the picture
use a longer transmission line
connect a booster
change the antenna orientation of location
twist the transmission line

⇒

Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): It is possible that a digital circuit gives the same output for different input voltages

Reason (R): A digital circuit is also called logic circuit.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a perfect conductor the incident and reflected wave combine to produce
a stronger incident wave
a stronger reflected wave
a standing wave which is not progressing
none of the above

⇒ A capacitor behave to d.c. as
short-circuit
an open-circuit
it behaves to a.c.
none of these.

⇒ A multivibrator can be used as a
cavity resonator
harmonic generator
wave form modifier
any of the above

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ Poor power factor
reduces load handling capability of electrical system
results in more power losses in the electrical system
overloads alternators, transformers and distribution lines
all

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ Nyquist stability criterion is based on a theorem from the theory of complex variables.
TRUE
FALSE

⇒ In an RC-coupled amplifier for improving the low frequency response
lower R_L is provided
more bias is used
less gain is provided
higher C_C is used

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ The terms RMS and average values apply only to sine waves.
TRUE
FALSE

⇒ Which of the following modes in circular waveguides are circularly symmetric?
TE₀₁
TE₀₂
both (a) and (b)
neither (a) nor (b)

⇒ A two port network is said to be reciprocal if
h₁₂ = - h₂₁
AD - BC = 1
y₁₂ = y₂₁
all

⇒

Assertion (A): In KVL equations involving mutually coupled circuits the sign of M terms can be positive or negative.

Reason (R): Dot convention helps in determining sign of M terms in KVL equations.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above