Question is ⇒ The superposition theorem is applicable to, Options are ⇒ (A) linear, non-linear and time variant responses, (B) linear and non-linear resistors only, (C) linear responses only, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The superposition theorem is applicable to, Options are ⇒ (A) linear, non-linear and time variant responses, (B) linear and non-linear resistors only, (C) linear responses only, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The superposition theorem is applicable to
A.	linear, non-linear and time variant responses [Wrong Answer]
B.	linear and non-linear resistors only [Wrong Answer]
C.	linear responses only [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A single phase half bridge inverter required to feed R-L loads needs
2 thyristors
4 thyristors
2 thyristors and two diodes
4 thyristors and 4 diodes

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒

Assertion (A): In simplifying block diagram the product of transfer functions in feed forward direction must remain the same.

Reason (R): In simplifying block diagram the product of transfer functions around a closed loop must remain the same.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ The radio receivers mostly used now a days are
TRF receivers
super heterodyne receivers
CW receivers
pulsed receivers

⇒ A class C amplifier uses
high Q tuned circuit
low Q tuned circuit
untuned circuit
either (b) or (c)

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For dielectrics in alternating field, polarizability a_e is a complex quantity. The imaginary part of a_e is zero for
ω = 0
ω → ∞
ω = 0 and ω → ∞
ω = natural frequency ω₀

⇒ For making a capacitor, the dielectric should have
high ∈_r
low ∈_r
∈_r = 1
∈_r neither too high nor too low

⇒ Consider following statements :

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

statement (1) is true and (2) is false
statement (1) and (2) both are true
statement (1) is false and (2) is true
statement (1) and (2) both are false

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The clear data and present input of the JK flip-flop are known as
direct inputs
synchronous inputs
indirect inputs
either direct inputs or synchronous inputs

⇒ The effective length of an 1/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.34λ² and η = 120p) is __________ .
0.6348 λ
0.5133 λ
0.1587 λ
0.3714 λ

⇒ Consider the following DO statement in Fortran 77 10
2
5
zero

⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
1 - e^-t
2 - 2e^-t
2 + 2e^-t
4 - 4e^-t

⇒ Which one is time invariant system?
y[n] = x[2n]
y[n] = x[n] x[n - 1]
y[n] = x[n/2]
all

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency is
100 rad/sec
10000 rad/sec
1000 rad/sec
more than 10000 rad/sec

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite

⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF

⇒ The logic circuit in the given figure realizes the func
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ For an ideal antenna, numerical value of directivity must be
∞
0
1
any value

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ Which of the following is not necessarily the advantage of SSB over double sideband, full carrier AM?
The signal is more noise resistant
More channel space is available
Transmitter circuits must be more stable, given better reception
Considerably less power is required for the same signal strength

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as
an open-circuit
a short-circuit
a pure resistance
all of the above

⇒ For the system in the given figure. The transfer function C(s)/R(s
G₁ + G₂ + 1
G₁ G₂ + 1
G₁ G₂ + G₂ + 1
G₁ G₂ + G₁ + 1

⇒ During induction heating of metals which of the following is abnormally high?
Frequency
Voltage
Current
Power factor

⇒ Which of the following is used to generate PDM?
Free running multi-vibrator
Monostable multi-vibrator
JK flip-flop
Schmitt trigger

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain