Question is ⇒ The standard intermediate frequency for FM ratio is, Options are ⇒ (A) 10.7 MHz, (B) 4.5 MHz, (C) 75 kHz, (D) 455 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The standard intermediate frequency for FM ratio is, Options are ⇒ (A) 10.7 MHz, (B) 4.5 MHz, (C) 75 kHz, (D) 455 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The standard intermediate frequency for FM ratio is
A.	10.7 MHz [Correct Answer]
B.	4.5 MHz [Wrong Answer]
C.	75 kHz [Wrong Answer]
D.	455 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is
100 kHz
100 MHz
500 kHz
108 kHz

⇒ For a diamagnetic material, μ_r = 1.
TRUE
FALSE

⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ An open coil has
zero resistance and inductance
zero resistance and high inductance
infinite resistance and zero inductance
infinite resistance and normal inductance

⇒ The phase velocity in a coaxial line is
greater than C
equal to C
less than C
not depend on C

⇒

Assertion (A): The scale a PMMC ammeter is linear.

Reason (R): The deflecting torque of PMMC is proportional to current in the coil.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The total electrical energy emitted overall space from an electron of charge e and radius r is
e/ε₀r²
e²/ε₀r
e²/4pε₀r²
e²/8pε₀r

⇒ A digital frequency counter can be converted to DVM by addition of a suitable
voltage controlled oscillator
D/A converter
power amplifier
operational amplifier

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ An electrical network with 8 independent nodes will have __________ nodal equations.
4
6
7
8

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒ A resistance strain gauge has a resistance of about
100 Ω
25 Ω
10 Ω
1 Ω

⇒ An antenna has 40 Ω resistance and 60 Ω radiation resistance. The efficiency of the antenna is
0.3
0.4
0.5
0.6

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ In a CE amplifier circuit, the output voltage
is very small
is always constant
depends on β
none of the above

⇒ The complicated shapes in the polar plots are only due to time constants in the numerator of transfer functions.
TRUE
FALSE

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ Which one of the following is an active component?
Diode (p-n)
Transistor as Amplifier
Transformer
Inductor

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ Which one of following is correct condition to check the stability of sysytem in terms of impulse response?
Σ(x(n)) < ∞
Σx(n) < 0
Σx(n) = 0
Σx(n) = ∞

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒ Laplacian of a scalar function v is
gradient of v
divergence of v
gradient of the gradient of v
divergence of the gradient of v

⇒ Consider the following statements about Infix and Post fix notations in Pascal

In Infix notation operators appear between the operands on which they operate.
In Post fix notation operators appear after the operand.
The Infix expression A + B - C + D will appear as AB + C - D + in post fix notation.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct