Question is ⇒ The speeds used in recording audio programs in house hold recorders are, Options are ⇒ (A) 38 cm/s and 9.5 cm/s, (B) 38 cm/s and 19 cm/s, (C) 9.5 cm/s and 4.75 cm/s, (D) 38 cm/s and 4.75 cm/s, (E) , Leave your comments or Download question paper.

Question is ⇒ The speeds used in recording audio programs in house hold recorders are, Options are ⇒ (A) 38 cm/s and 9.5 cm/s, (B) 38 cm/s and 19 cm/s, (C) 9.5 cm/s and 4.75 cm/s, (D) 38 cm/s and 4.75 cm/s, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The speeds used in recording audio programs in house hold recorders are
A.	38 cm/s and 9.5 cm/s [Wrong Answer]
B.	38 cm/s and 19 cm/s [Wrong Answer]
C.	9.5 cm/s and 4.75 cm/s [Correct Answer]
D.	38 cm/s and 4.75 cm/s [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a crystal
the frequencies of series and parallel resonance are equal
the frequency of series resonance is more than frequency of parallel resonance
the frequency of parallel resonance is more than frequency of series resonance
None of the above

⇒ Consider the following statements associated with two port networks.

Z₁₂ = Z₂₁
Y₁₂ = Y₂₁
h₁₂ = h₂₁
AD - BC = 1

Which one of the statement given above are correct?
1, 2, 3
2, 3, 4
1, 3, 4
1, 2, 4

⇒ A square corner reflector is used in which of the following?
TV broadcast
Point-to-point communication
Radio astronomy
All of the above

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B

⇒ If P = 250 W and p.f. = 0.707 lagging, Q =
250 vars
- 250 vars
176.7 vars
- 176.75 vars

⇒ A computer program is used to read N and print the sum 1² + 2² + 3² +.....+ N². If N = 10, the print out will show the number
100
10
385
285

⇒ In atomic physics, a state with l = 0 is called p state.
TRUE
FALSE

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ The modulation index of an FM is changed from 0 to 1. How does the transmitted power change?
Gets halved
Gets doubled
Gets increased by 50 percent
Remains unchanged

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ In the case of a 70-MHz IF carrier for a transponder bandwidth of 36 MHz, energy must lie between MHz.
34 and 106
52 and 88
106 and 142
34 and 142

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ If W_F is the Fermi level, then in a metal at T = 0
all energy levels above W_F filled, all those below W_F are empty
all energy levels below W_F are filled, all those above W_F are empty
some energy levels, both below and above W_F, are filled
all energy levels below and above W_F are filled

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ In JK flip flop toggle state exists if
J = 0, K = 1
J = 1, K = 0
J = 0, K = 0
J = 1, K = 1

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒ A lossless transmission line with air dielectric is 6 m long. What is the line length at 30 MHz?
1 wavelength long
0.5 wavelength long
0.6 wavelength long
0.25 wavelength long

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In broadcast television, the number of lines per frame is chosen to be odd number to
reduce the required bandwidth
improve resolution
reduce peak power requirement
make interlacing easier

⇒ The depletion layer across a P⁺ n junction lies
mostly in the P⁺ region
mostly in n region
equally in both the P⁺ and n-region
entirely in the P⁺ region

⇒ In 8085, out of interrupts given below, one particular interrupts is quite different from others, This interrupt is
RST 5.5
RST 6.5
RST 7.5
none of these

⇒

Assertion (A): Strain measurement using strain gauge invariably requires a dummy strain gauge.

Reason (R): The resistance of strain gauge depends on temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The MOS symbols shown indica
1, 3, 6
2, 4, 6
1, 3, 5
2, 3, 6