Question is ⇒ The speed transducer using a drag cup rotor has the main advantage of, Options are ⇒ (A) very high accuracy, (B) low energy requirement, (C) cheap construction, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The speed transducer using a drag cup rotor has the main advantage of, Options are ⇒ (A) very high accuracy, (B) low energy requirement, (C) cheap construction, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The speed transducer using a drag cup rotor has the main advantage of
A.	very high accuracy [Wrong Answer]
B.	low energy requirement [Correct Answer]
C.	cheap construction [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The requirements of carrier frequency are
precise frequency value
low frequency drift
both (a) and (b)
neither (a) nor (b)

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ VLF waves are used for communication system because
of low power requirement
they are least prone to distortion
they penetrate the ionosphere easily
the transmitting antennas are of convenient size

⇒ Bus bars are always meant for very heavy currents.
TRUE
FALSE

⇒ If A = 20 and B = - 7 in PASCAL, A mod B =
6
2
-1
3

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ A specimen of a material has a resistivity of 1.78 x 10⁸ ohm-m. The material is
semiconductor
conductor
semiconductor or conductor
insulator

⇒ The wavelength of an electromagnetic wave after reflection at angle on a surface
remains same as the wavelength perpendicular to the surface
remains same in the free space
increases in actual direction of propagation
decreases in actual direction of propagation

⇒ Status register in the 8156 is read with
IN 20 H
OUT 20 H
either (a) or (b)
none of the above

⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
EI only
SIM only
EI and SIM both
None

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ The static characteristic of an adequately forward biased P-n junction is a straight line, if the plot is of __________ V_s → versus
log I V_s log V
log I V_s V
I V_s log V
I V_s V

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒ A geostationary satellite is one which
hangs motionless in space about 36000 km about Earth
travels around the Earth in 24 hours
remains stationary above the Earth
appears stationary to everybody on Earth

⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)

⇒ Which of the following is true in a tape recorder?
Vow is due to variation in motor speed but flutter is due to some other reason
Both vow and flutter are due to variations in motor speed
Flutter is due to variation in motor speed but vow is due to some other reason
Neither vow nor flutter is due to variation in motor speed

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ The colour code of a carbon resistance is yellow-violet-orange silver. The value of resistance is
57000 Ω ± 5%
47000 Ω ± 10%
47000 Ω ± 5%
57000 Ω ± 5%

⇒

Assertion (A): Maxwell bridge is for measuring inductance of medium magnitude.

Reason (R): In Maxwell's bridge the unknown inductance is measured by comparing it with a capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Consider the following

A signal f(t) and its Hilbert transform f_h(t) have the same energy density spectrum
A signal f(t) and its Hilbert transform, f_h(t) have the same auto correlation function
A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only

⇒ A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is
[exp (- 2t) + exp (-4t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t) - exp (-t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t)] u(t)
[-0.5 exp (- 2t) + 1.5 exp (-4t)] u(t)

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, X_L = 50 Ω, X_C is
10 Ω
14.14 Ω
7.07 Ω
50 Ω

⇒

Assertion (A): Copper is a good conductor of electricity.

Reason (R): Copper has a face centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ De-emphasis circuit is used
to attenuate high frequencies
to attenuate low frequencies
to attenuate mid-band frequencies
None of the above

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒ In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
zener current is very small
zener current is very large
zener current is neither small nor large
None of the above

⇒ Which is correct for a transfer function?
The poles and zero must be complex
If the poles and zeros are complex or imaginary, they must be conjugate
If the poles and zeros are complex they must be simple
If a zero is imaginary, it must be simple