Question is ⇒ The skip distance does not depends upon, Options are ⇒ (A) the power transmitted, (B) type of wave propagation, (C) angle of beaming of the wave, (D) frequency of the signal transmitted, (E) , Leave your comments or Download question paper.

Question is ⇒ The skip distance does not depends upon, Options are ⇒ (A) the power transmitted, (B) type of wave propagation, (C) angle of beaming of the wave, (D) frequency of the signal transmitted, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The skip distance does not depends upon
A.	the power transmitted [Wrong Answer]
B.	type of wave propagation [Correct Answer]
C.	angle of beaming of the wave [Wrong Answer]
D.	frequency of the signal transmitted [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The following circuit is implementation of

Sum of full adder

Carry of half adder

Difference of full subtractor

<
(i) only
(iii) only
(ii) only
(i) and (ii)

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ Resonant circuits are used in
audio amplifiers
RF amplifiers
both audio and RF amplifiers
none of the above

⇒ A dynamic RAM cell which holds 5 V has to be refreshed every 20 ms so that the stored voltage does not fall by more than 0.5 V. If the cell has a constant discharge current of 0.1 pA, the storage capacitance of cell is
4 x 10^-6 F
4 x 10^-9 F
4 x 10^-12 F
4 x 10^-15 F

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ Work function of oxide coated cathode is much lower than that of tungsten cathode.
TRUE
FALSE

⇒ When two port networks are connected in cascade, it is more convenient to use hybrid parameters.
TRUE
FALSE

⇒ Given figure shows a unity feedback system. The ratio of time constants for open loop and closed loop response
0.0423611111111111
0.0840277777777778
0.126388888888889
0.0854166666666667

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is
same as BPSK
half of that in BPSK
one-fourth of that in BPSK
none of the above

⇒ Commercial ECL gates use two ground lines and one negative supply to
reduce power consumption
increase fan out
reduce loading effect
eliminate the effect of power line glitches on the biasing circuit

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ The principal of locality of reference justifies the use of
interrupts
DMA
virtual memory
cache memory

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒ Effective Q of the equivalent electrical circuit of quartz crystal is of the order of
200
2000
20000
200000

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The complete video signal consists of
video signal and synchronising pulses
video signal, synchronising pulses and blanking pulses
video signal corresponding to picture information only
video signal and blanking pulses

⇒ Half power point directions for broadside is
60°
30°
45°
at any angle

⇒ P flag is for parity.
TRUE
FALSE

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒ Which of these is the most recent display device?
LED
LCD
VF
(a) and (c)

⇒ When signed numbers are used in binary arithmetic, which of the following has unique representation for zero?
Sign-magnitude
1's complement
2's complement
9's complement

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a cascade amplifier, the intermediate stages are always in
CC configuration
CB configuration
CE configuration
any of the above