Question is ⇒ The simplest mixer circuit for public address system uses, Options are ⇒ (A) fixed resistances, (B) variable resistances, (C) inductances, (D) capacitances, (E) , Leave your comments or Download question paper.

Question is ⇒ The simplest mixer circuit for public address system uses, Options are ⇒ (A) fixed resistances, (B) variable resistances, (C) inductances, (D) capacitances, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The simplest mixer circuit for public address system uses
A.	fixed resistances [Wrong Answer]
B.	variable resistances [Correct Answer]
C.	inductances [Wrong Answer]
D.	capacitances [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ Which of the following modes in circular waveguides are circularly symmetric?
TE₀₁
TE₀₂
both (a) and (b)
neither (a) nor (b)

⇒ Tracking of extra terrestrial objects requires
high transmitting power
very sensitive receiver
fully steerable antenna
all of the above

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ A lossless transmission line is connected to two identical voltage source as shown in figu
∞
100
50
25

⇒ Three resistance of 15 Ω each are connected in delta. The resistance of equivalent star will have a value of
15 Ω
5 Ω
5/3 Ω
45 Ω

⇒ The forbidden energy gap in semiconductors
is always zero
lies just below the valence band
lies between the valence band and the conduction band
lies just above the conduction band

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the circuit shown, the device connected to Y5 can have address in the r
2000 - 20FF
2D00 - 2DFF
2E00 - 2EFF
FD00 - FDFF

⇒ In a CE amplifier circuit the dc voltage between emitter and ground
is always zero
cannot be zero
may or may not be zero
is negative

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒

Match the following:

	List I (Types of N-bit ADC)		List II (Characteristics)
A.	Flash converter	1.	Integrating Type
B.	Successive	2.	Fastest converter approximation
C.	Counter ramp	3.	Maximum conversion time = N bits
D.	Dual slow	4.	Used a DAC in its feedback path

A-2, B-3, C-4, D-1
A-1, B-3, C-4, D-2
A-2, B-4, C-3, D-1
A-1, B-4, C-3, D-2

⇒ Radiation pyrometer is used to measure temperature in the range of
-200 to 500° C
0 to 500° C
500 to 1200° C
1200 to 2500° C

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ Schmitt trigger is used for wave shaping.
TRUE
FALSE

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
the faster the AGC time constant, the more accurate the output
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC

⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc
0
1 rad/sec
4 rad/sec
16 rad/sec

⇒ The number of protons in a silicon atom are
4
8
12
14

⇒ For the circuit of the given figure, the output equatio
Y = ABCD
Y = AB + CD
Y = A + BCD
Y = ABC + D

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒

Assertion (A): Decoder is not a combinational circuit.

Reason (R): Every memory element of semi conductor form has a decoder.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The wavelength of an electromagnetic wave after reflection at angle on a surface
remains same as the wavelength perpendicular to the surface
remains same in the free space
increases in actual direction of propagation
decreases in actual direction of propagation

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒ D FF can be used as a
differentiator
divider circuit
delay switch
none

⇒ According to Barkhausen criteria in order to sustain the oscillations
loop gain of the circuit must be negligible
loop gain of the circuit must be equal to unity
the phase shift around the circuit must be 180°
none of the above

⇒ Cache memory size is about
a few KB
about 500 KB
about 1 MB
about 50 MB

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE