Question is ⇒ The shunt admittance of a transmission line is given by, Options are ⇒ (A) γ = R + jωL, (B) γ = R - jωL, (C) γ = G + jωC, (D) γ = jωGC, (E) , Leave your comments or Download question paper.

Question is ⇒ The shunt admittance of a transmission line is given by, Options are ⇒ (A) γ = R + jωL, (B) γ = R - jωL, (C) γ = G + jωC, (D) γ = jωGC, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The shunt admittance of a transmission line is given by
A.	γ = R + jωL [Wrong Answer]
B.	γ = R - jωL [Wrong Answer]
C.	γ = G + jωC [Correct Answer]
D.	γ = jωGC [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a four variable K map eight adjacent cells give
single variable term
two variable term
three variable term
four variable term

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ In a two phase servomotor the voltages applied to the two stator windings
are equal in magnitude and are in phase
are unequal in magnitude but are in phase
are equal in magnitude but have a phase difference of 90°
are unequal in magnitude and have a phase difference of 90°

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ When a transistor is to be at a temperature above 25°C
smaller heat sink be provided
maximum power rating be derated
biasing circuit must be strengthened
earth connections must be connected through a resistor

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ The figures shows the symbo
p channel depletion MOSFET
p channel enhancement MOSFET
complementary MOSFET
p channel JFET

⇒ A dc machine has 6 poles all connected in series. Each pole has 9 H inductance and field current is 2 A. Total inductance and total energy stored are
9 H and 18 J
18 H and 36 J
54 H and 108 J
108 H and 216 J

⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above

⇒ Which of the following devices should be used for accurate measurement of a low dc voltage?
Small range moving coil voltmeter
Dc potentiometer
Small range thermocouple voltmeter
Hot wire instrument

⇒ The integral of a unit impulse is
a unit step function
a ramp function of slope 1
a pulse function of magnitude 1
none of the above

⇒ In p type semiconductor holes are majority carriers.
TRUE
FALSE

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ A number of impulses spaced fron one another form an impulse train.
TRUE
FALSE

⇒ The nodal method of circuit analysis is based on
KVLs, ohm law
KCLs, ohm law
KCLs, KVL
KCL, KVL, ohms law

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ A communication channel with AWGN operating at a signal to noise ratio SNR >> 1 and bandwidth B has capacity C₁. If the SNR is doubled keeping B constant, the resulting capacity C₂ is given by
C₂ ≈ 2C₁
C₂ ≈ C₁ + B
C₂ ≈ C₁ + 2B
C₂ ≈ C₁ + 0.3B

⇒ N circles for a = a₁, and a = a₁ ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE

⇒ For stable network the real parts of poles and zeros of driving point functions must be
negative
negative or zero
zero
positive

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the velocity propagation will be
15.8303 km/s
15.830 km/s
1.583 km/s
0.1583 km/s

⇒ There is no radiation at right angles to the plane of the array, is end fire array.
TRUE
FALSE

⇒ When Schrodinger equation is applied to the motion of electron in the field of protons, the physically acceptable solutions for the wave function exist for quantum number which are
2
3
4
5

⇒

Assertion (A): A half cycle of sine wave can be expressed as sum of sine wave and another sine wave shifted by T/2 where T is the time period.

Reason (R): The function u(t - t₀) - u(t - t₀ - T) is a gate function occuring at t = t₀ and of duration T.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication