Question is ⇒ The self inductances of two coils are 27 H and 3 H. If the winding or coils is such that 50% of flux of one links the other, the mutual inductance is, Options are ⇒ (A) 30 H, (B) 24 H, (C) 9 H, (D) 4.5 H, (E) , Leave your comments or Download question paper.

Question is ⇒ The self inductances of two coils are 27 H and 3 H. If the winding or coils is such that 50% of flux of one links the other, the mutual inductance is, Options are ⇒ (A) 30 H, (B) 24 H, (C) 9 H, (D) 4.5 H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The self inductances of two coils are 27 H and 3 H. If the winding or coils is such that 50% of flux of one links the other, the mutual inductance is
A.	30 H [Wrong Answer]
B.	24 H [Wrong Answer]
C.	9 H [Wrong Answer]
D.	4.5 H [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ Damping ratio =
actual resistance/critical resistance
critical resistance/actual resistance
critical resistance
none of the above

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ Which of the following statements is not correct?
Propagation delay is the time required for a gate to change its state
Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state
Fan-in of a gate is always equal to fan-out of the same gate
Operating speed is the maximum frequency at which digital data can be applied to a gate

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
2.5
12.5
25
125

⇒ Wien bridge uses
lead network
lag network
lead-lag network
Both (a) and (b)

⇒ A series RL circuit is excited by a voltage v(t) = V_msin (ωt + Φ). The transient current will be zero if
Φ = 0
ω = 0
Φ = tan^-1 (ωL/R)
ω - tan^-1 (ωL/R) = p/2

⇒ For good quality signal transmission all frequency components should have the same transmission delay, t_d and same phase shift-Φ_s. What can be said about the statement?
Correct
True from t_d but not for Φs
Not true for t_d but true for Φ_s
Both t_d and Φ_s are not involved in quality

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0

⇒ N-type silicon is obtained by doping silicon with
germanium
aluminium
boron
phosphorus

⇒

Assertion (A): A good algorithm should be fast, require minimal computer memory and time.

Reason (R): Many times an algorithm is prepared in the form of a flow chart.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The dual of a link is
twig
node
loop
tree branch

⇒ The antenna most commonly used for TV broadcasting in the UHF band is
turnstile antenna
dipole antenna
yagi antenna
rhombic antenna

⇒ The depletion layer across a P⁺ n junction lies
mostly in the P⁺ region
mostly in n region
equally in both the P⁺ and n-region
entirely in the P⁺ region

⇒ An ohmmeter is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ In the expression b = 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?
2.1 / 1.2
1.2 * 3.1
2.1 / 1.2 * 3.1
3 / 7.1

⇒ Consider the following statements about advantages of phase discriminator over slope detector

Fewer tuned circuits
Greater limiting
Better linearity
Easy alignment

Which of the above are true?
1, 2, 3, 4
2, 3, 4
1, 2, 3
1, 3, 4

⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved

⇒ If the diameter of a wire is doubled, its current carrying capacity becomes
one-fourth
half
twice
four times

⇒ The maximum usable frequency for the 'E' layer is 10 MHz.
TRUE
FALSE

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ Consider the following statements

Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒ In solid insulator materials having only one kind of atom, the types of polarization which exist are
electronic only
electronic and ionic
electronic, ionic and permanent
electronic and permanent

⇒ The circuit in figur
positive clamper
negative clamper
positive peak clipper
negative peak clipper

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron