Question is ⇒ The r.m.s. value of pure cosine function is, Options are ⇒ (A) 0.5 of peak value, (B) 0.707 of peak value, (C) Same as peak value, (D) Zero, (E) , Leave your comments or Download question paper.

Question is ⇒ The r.m.s. value of pure cosine function is, Options are ⇒ (A) 0.5 of peak value, (B) 0.707 of peak value, (C) Same as peak value, (D) Zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The r.m.s. value of pure cosine function is
A.	0.5 of peak value [Wrong Answer]
B.	0.707 of peak value [Correct Answer]
C.	Same as peak value [Wrong Answer]
D.	Zero [Wrong Answer]
View Answer 9 -10 Explanation:- Answer : B Discuss it below : Victor Ofori-Danquah Said on 2020-09-27 13:34:11 A purely resistive impedance is also said to be A. nonconductive. B. noncapacitive. C. noninductive. D. nonreactive. !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Higher the Q of a series circuit
Broader its resonance curve
Narrower its pass band
Greater its band width
Sharper its resonace

⇒ A sine wave of voltage varies from zero to maximum of 200 V. How much is the voltage at the instant of 30° of the cycle ?
50V
82.8V
100V
173.2 V

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees
90
60
45
30

⇒ In an A.C. circuit, a low value of kVAR compared with kW indicates
Low efficiency
High power factor
Unity power factor
Maximum Load current

⇒ The shunt element in a band pass filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C

⇒ For the same peak value, which of the following wave has the least mean value ?
Half wave rectified sine wave
Triangular wave
Sine wave
Square wave

⇒ For the same peak value of voltage which wave form will have the least r.m.s. value ?
Sine wave
Square wave
Triangular wave
Full wave rectified sine wave

⇒ The power factor of a D.C. circuit is always
Less than unity
Unity
Greater than Unity
Zero

⇒ In A.C. circuit laminated iron is invariably used in order to
Reduce eddy current loss
Increase heat radiation
Make assembly cheap and easier
Reduce circuit permeability

⇒ Selectivities of different resonance circuits are compared in terms of their
Impedances
Reactances
Frequencies
Band widths

⇒ How much r.m.s. current does a 300 W. 200V bulb take from the 200 V, 50 Hz power line ?
0.5A
1.5 A
2A
3A

⇒ Ohm is the unit of all of the following except
Inductive reactance
Capacitive reactance
Resistance
Capacitance

⇒ The shunt element of prototype high pass filter is
Resistive
Inductive
Capacitive
Combination of L and C

⇒ The form factor of D.C. supply voltage is always
Zero
0.5
Unity
Infinite

⇒ A heater is rated as 230 V, 10 KW, AC. The value 230 V refers t
Average voltage
r.m.s. voltage
Peak voltage
None of these

⇒ The reflection co-efficient of the simplest standing wave is
+1
1
Zero
Infinity

⇒ The dual of a link is
Twig
Node
Loop
Tree branch

⇒ Inductance affects the direct current flow
Only at the time of turning off
Only at the time of turning on
At the time of turning on and off
At all the time of operation

⇒ The peak value of a sine wave is 200 V. Its average value is
127.4V
141.4V
282.8V
200 V

⇒ Which of the following is not a non-linear element ?
Transistor
Heater coil
Diode
Electric arc with unlike electrodes

⇒ In a series resonant circuit, the impedance of the circuit is
Maximum
Minimum
Zero
Infinite

⇒ Which of the following waves has the highest value of peak factor '?
Square wave
Sine wave
Half wave rectifier sine wave
Triangular wave

⇒ When an alternating current passes through an ohmic resistance the electrical power converted into heat is
Apparent power
True power
Reactive power
None of the above

⇒ In an A.C. circuit I sin Φ is called
Active component
Wattless component
Any of the above
None of these

⇒ In the R - L - C containing R = 4.5ω L = 0.06 H,C = 0.6 µF the power factor will be
Zero
Lagging
Leading
Unity

⇒ Power factor of electric bulb is
Zero
Lagging
Leading
Unity

⇒ In A.C. circuit the power curve is a sine wave having
Double the frequency of voltage
Same frequency as that of voltage
Half the frequency of the voltage
None of these

⇒ In a R-L-C series circuit if voltage V across the circuit is reduced to half the current I will change to
2 I
I/2
3/4 I
5/8 I

⇒ Power factor of the following circuit will be unity
Inductance
Capacitance
Resistance
Both (A) and (B)

⇒ The series element of a band stop filter is
Capacitive
Inductive
Parallel combination of L and C
Series combination of L and C