Question is ⇒ The ripple factor of power supply is a measure of, Options are ⇒ (A) its filter efficiency, (B) diode rating, (C) its voltage regulation, (D) purity of power output, (E) , Leave your comments or Download question paper.

Question is ⇒ The ripple factor of power supply is a measure of, Options are ⇒ (A) its filter efficiency, (B) diode rating, (C) its voltage regulation, (D) purity of power output, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The ripple factor of power supply is a measure of
A.	its filter efficiency [Wrong Answer]
B.	diode rating [Wrong Answer]
C.	its voltage regulation [Wrong Answer]
D.	purity of power output [Correct Answer]
View Answer 7 -16 Explanation:- Answer : D Discuss it below : Vijay Bhardwaj Said on 2020-05-16 20:47:05 Zener diode has a DC power dissipation rating of 500mw and a zener voltage rating of 6.8 volt the value of lGM is !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ 6 bytes means
6 bits
24 bits
48 bits
96 bits

⇒ Consider the signal S(t) shown bel
8
12
16
18

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ Which of the following microphones has highest output impedance?
Carbon
Ribbon
Crystal
Condenser

⇒ The causal system given below is _______
minimum phase
maximum phase
mixed phase
none of these

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ For a bit rate of 8 kbps, the best possible values of the transmitted frequencies in a coherent binary FSK system are
16 kHz and 20 kHz
20 kHz and 32 kHz
20 kHz and 40 kHz
32 kHz and 40 kHz

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒

Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them

Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
(t^2* e^-2t) U(t)
(t^* e^2t) U(t)
(te^-2t) U(t)
(te^2t) U(t)

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ The access time of ROM using bipolar transistors is about
1 sec
1 mili sec
1 μ sec
1 n sec

⇒ D/A converters are generally
weighted resistor network
binary ladder network
either (a) or (b)
neither (a) nor (b)

⇒ The colour code of a carbon resistance is yellow-violet-orange silver. The value of resistance is
57000 Ω ± 5%
47000 Ω ± 10%
47000 Ω ± 5%
57000 Ω ± 5%

⇒ In the circuit, shown in figure, V₀ = V_i. The values of 1, m, n are: (x represents don't care conditi
0, 1, 1
∞, x, x
x, ∞, x
0, x, ∞

⇒ The ROC of sequence in the Z.T. of sequence x[n] = aⁿ ∪ [n] is
z > a
z < a
|z| > a
|z| < a

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ The symbol in figure is
DIAC
P-N junction diode
Schottky diode
None of the above

⇒

Assertion (A): Klystron amplifiers use one or more intermediate cavities in addition to buncher and catcher cavity.

Reason (R): When one or more intermediate cavities are used the bandwidth can be increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ A unipole is also known as
omnidirectional radiator
unidirectional radiator
line radiator
none of the above

⇒ The accumulator drives the ALU.
TRUE
FALSE

⇒ In case of antenna the lower value of Q indicates
higher bandwidth
lower bandwidth
higher distortion
lower distortion

⇒ Millman's theorem is the best to find
equivalent voltage or current source
equivalent voltage source
equivalent voltage and resistance of a circuit
none of the above