Question is ⇒ The resonance frequency of the circui, Options are ⇒ (A) 5.4 Kn2, (B) 4.5 Kn2, (C) 5 Kn2, (D) ∞, (E) , Leave your comments or Download question paper.

Question is ⇒ The resonance frequency of the circui, Options are ⇒ (A) 5.4 Kn2, (B) 4.5 Kn2, (C) 5 Kn2, (D) ∞, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resonance frequency of the circui
A.	5.4 Kn₂ [Wrong Answer]
B.	4.5 Kn₂ [Correct Answer]
C.	5 Kn₂ [Wrong Answer]
D.	∞ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒ The torque in induction wattmeters due to
capacitive current
electrostatic effect
hall effect
eddy currents

⇒ Pilot-carrier transmission is one in which
only one sideband is transmitted
one sideband and carrier are transmitted
only two sidebands are transmitted
two sidebands as well as a trace of carrier are transmitted

⇒ Which of the following microphones has highest output impedance?
Carbon
Ribbon
Crystal
Condenser

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ The rated current of a thyristor is 40 A. The holding current will be about :
20 A
0.0416666666666667
100 mA
10 mA

⇒ With respect to transmission parameters, which one of the following is correct?
A and B are dimensionless
B and C are dimensionless
A and D are dimensionless
B and D are dimensionless

⇒ A parallel plate capacitor has area of plate A and plate separation d. Its capacitance is C. A metallic plate P of area A and negligible thickness is added as shown in Figure. The new value of capacitance
C
2C
0.5 C
0.25 C

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ The word enhancement mode is associated with
tunnel diode
MOSFET
JFET
photo diode

⇒ Consider the following statement S₁ and S_{2S₁ is False, S₂ is true
S₁ and S₂ both are true
S₁ and S₂ both are false
S₁ is true, S₂ is false}

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ Whether a linear system is stable or unstable that it
is a property of the system only
depends on the input function only
both (a) and (b)
either (a) or (b)

⇒ Consider the following statement: At finite temperature, magnetic dipoles in a material are randomly oriented giving low magnetization. When magnetic field H is applied, the magnetization?

Increases with H
Decreases with H
Decreases with temp for constant H

Which of the statement given above is/are correct?
1
2
2, 3
1 and 3

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ For an op-amp source follower circuit
input and output voltages have same magnitude
output and input voltages are in phase
output and input voltages are in phase but have different magnitudes
output and input voltages have same magnitude and are in phase

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒ Which of the following flip-flops is used as latch?
JK flip-flop
D flip-flop
RS flip-flop
T flip-flop

⇒ Which of the following statement is false?
The zener diode is uses as a constant voltage source
The SCR is a silicon rectifier with a gate electrode to control when current flows from cathode to anode
The gate electrode in the FET corresponds to the collector in a bipolar transistor
None of the above

⇒

Assertion (A): The gain of an FET amplifier can be changed by changing g_m

Reason (R): Most receivers use automatic gain control to counteract changes in volume caused by fading

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For a random variable x following the probability density function, p(x), shown in figure, the mean and the variance are respective
1/2 and 2/3
1 and 4/3
1 and 2/3
2 and 4/3

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ In an op-amp differentiator
the amplitude of output is proportional to rate of change of input
the amplitude of output is proportional to input
output occurs when input is finite and constant
polarity of input and output is the same

⇒ A low noise device is most important
at front end of equipment
in the last stage of equipment
in the middle stages of equipment
both (b) and (c)

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ The main application of enhancement mode MOSFET is in
amplifier circuits
oscillator circuits
switching circuits
all of the above

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒ Out of the three transforms viz. Z-transform, Laplace transform and Fourier transform
all three are used in continuous time domain
all three are used in both continuous time domain and discrete time domain
Z transform is used in continuous time domain while Laplace and Fourier transforms are used in discrete time domain
Z transform is used is discrete time domain while Laplace and Fourier transforms are used in continuous time domain

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz