Question is ⇒ The resistivity of ferrites is, Options are ⇒ (A) very much lower than that of the ferromagnetic metals, (B) slightly lower than that of the ferromagnetic materials, (C) slightly higher than that of the ferromagnetic metals, (D) very much higher than that of the ferromagnetic metals, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistivity of ferrites is, Options are ⇒ (A) very much lower than that of the ferromagnetic metals, (B) slightly lower than that of the ferromagnetic materials, (C) slightly higher than that of the ferromagnetic metals, (D) very much higher than that of the ferromagnetic metals, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistivity of ferrites is
A.	very much lower than that of the ferromagnetic metals [Wrong Answer]
B.	slightly lower than that of the ferromagnetic materials [Wrong Answer]
C.	slightly higher than that of the ferromagnetic metals [Wrong Answer]
D.	very much higher than that of the ferromagnetic metals [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 K ohm is also in series with the diode. The current is
7 mA
6.3 mA
0.7 mA
0

⇒ The density of the dynamic RAM is
more than that of static RAM
less than that of static RAM
equal to that to static RAM
equal to or more than that of static RAM

⇒ In a bipolar junction transistor the base region is made very thin so that
recombination in base region is minimum
electric field gradient in base is high
base can be easily fabricated
base can be easily biased

⇒

Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.

Reason (R): For a type of system velocity error is zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a transmission line, losses due to dielectric heating are
proportional to voltage and inversely proportional to Z₀
proportional to voltage and proportional to Z₀
proportional to current and proportional to Z₀
proportional to current and inversely proportional to Z₀

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
13.5 m
3 m
88/3 m
3/88 m

⇒ When the circuit is switched on, the loop gain of a Wien bridge oscillator is
1
more than 1
less than 1
about 0.5

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ The theoretical maximum efficiency of a half wave diode rectifier is
0.406
0.5
0.812
slightly less than 100%

⇒ A very reliable service has to be established between two points on earth separated by 1000 km. The band that will be used as
MF
VHF
VLF
HF

⇒ The noise figure of FET circuit is
independent of the quiescent point
dependent on the quiescent point only
dependent on the triggering mechanism
independent of all above

⇒ If f(t) = 1, F(jω) = 2p δ(ω).
TRUE
FALSE

⇒ The average load current supplied by a thyristor depends on
firing angle
firing frequency
magnitude of gate current
all of the above

⇒ The closing of switch S₁ and S₂ in figure will ligh
lamp L₁ only
lamps L₁ and L₂
none of them
lamp L₂ only

⇒ If we manage to __________ our natural resources, we would leave a better planet for our children.
uphold
restrain
Cherish
conserve

⇒ The analog signal given below is sampled by 600 samples per se
600 Hz
120 Hz
300 Hz
360 Hz

⇒ In 3 phase power measurement by two wattmeter method, both wattmeters had equal reading. The power factor of load is
1
0.5 lagging
0.5 leading
0

⇒ It has been found that in a rectifier circuit with RC filter one RC section reduces ripple by 15%. Two RC sections are used in cascade the reduction in ripple would be
0.15
0.3
1.5
2.25

⇒ In an RLC series circuit having finite values of RLC, the phase difference between applied voltage and current is
always 0°
between 0 and 180°
between 0 and 90°
always 90°

⇒ If A = 3 + j1, A⁴
100 ∠18.43°
100 ∠73.72°
10 ∠18.43°
10 ∠73.72°

⇒ Which one most appropriate dynamic system?
y(n) + y(n - 1) + y(n + 1)
y(n) + y(n - 1)
y(n) = x(n)
y(n) + y(n - 1) + y(n + 3) = 0

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ Typical value of reverse current in a semiconductor diode is
0.0416666666666667
0.1 A
1 μA
0.1 μA

⇒ Which of these has the highest dielectric strength?
Mica
Air
Cotton
Rubber

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25