Question is ⇒ The resistance R<sub>AB</sub> in the circui, Options are ⇒ (A) 10 Ω, (B) 12 Ω, (C) 9 Ω, (D) 3 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistance R<sub>AB</sub> in the circui, Options are ⇒ (A) 10 Ω, (B) 12 Ω, (C) 9 Ω, (D) 3 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistance R_AB in the circui
A.	10 Ω [Wrong Answer]
B.	12 Ω [Wrong Answer]
C.	9 Ω [Correct Answer]
D.	3 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, the current after a long time after closing of switc
0.0416666666666667
0.0833333333333333
0
infinity

⇒ In an ordinary thyristor
turn on and turn off times are equal
turn on time is more than turn off time
turn off time is more than turn on time
turn on time may be equal, less than or more than turn off time

⇒ In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is
150 A
75 A
50 A
300 A

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ In a P-N-P transistor, electrons flow
into the transistor at the collector only
into the transistor at the base and the collector leads
out of the transistor at base and collector leads
out of the transistor at base, collector as well as emitter leads

⇒ In figure, the current through 10 V batter
0
0.5 A charging
0.5 A discharging
none of the above

⇒ While obtaining minimal SOP expression
all do not care terms are ignored
all do not care terms are treated as 1
all do not care terms are treated as 0
only such do not care terms which aid minimization are treated as 1

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be
24.09 MHz
24.54 MHz
25.45 MHz
25.91 MHz

⇒ An RC impedance function has a constant value at s = 0. The last element in the first cauer synthesis
will be a capacitor
may be R or C
will be R
will depend on the behaviour of function at s = ∞

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai
i (t) = e^-1 - e^-3t
i (t) = e^-1 - 2e^-2t
i (t) = e^-1 - e^-2t
i (t) = e^-1 - e^-4t

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ A-P type material has an acceptor ion concentration of 1 x 10¹⁶ per cm³. Its intrinsic carrier concentration is 1.48 x 10¹⁰/ cm. The hole and electron mobilities are 0.05m²/V-sec and 0.13 m²/V-sec respectively calculate the resistivity of the material
12.5 Ω-cm
1.25 Ω-cm
0.125 Ω-cm
125 Ω-cm

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1

⇒ An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is
OFFFH
1000H
B9FFH
BA00H

⇒ Electrons can be emitted from a metal surface due to high electric field.
TRUE
FALSE

⇒ Decimal -90 equals __________ in 8 bit 2s complement
1000 1000
1010 0110
1100 1100
0101 0101

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ The correct sequence of events to improve system stability is
insert derivative action, use negative feedback, reduce gain
reduce gain, use negative feedback, insert derivative action
reduce gain, insert derivative feedback, use negative feed back
use negative feedback, reduce gain, insert derivative action

⇒ The value of VSWR is taken as ∞ when the line is
short-circuited
open-circuited
terminated with full load
terminated with load equal to the characteristic impedance of the load

⇒

Match the following:

	List I (Signal)		List II (Value)
A.	AM	1.	0 0.5
B.	DSB - SC	2.	1
C.	SSB	3.	2
D.	FM (β = 2)	4.	16
E.	FM (β = 5)	5.	8

A-1, B-3, C-2, D-5, E-4
A-3, B-3, C-1, D-5, E-4
A-2, B-1, C-4, D-5, E-5
A-4, B-2, C-5, D-3, E-1

⇒ If a_ac for transistor is 0.98 then β_ac is equal to
51
49
47
45

⇒ For an n-channel JEFT having drain source voltage constant if the gate source voltage is increased (more negative) pinch off would occur for
high values of drain current
saturation values of drain current
zero drain current
gate current equal to the drain current

⇒ The memory segment registers in 8086 are denoted by
AS, BS, CS, DS
BS, CS, SS, ES
CS, DS, SS, ES
DS, ES, FS, SS

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch