Question is ⇒ The resistance of a metallic wire would, Options are ⇒ (A) increase as the operating frequency increase, (B) decrease as the operating frequency increase, (C) remain unaffected on increasing the operating frequency, (D) first increase then decrease, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistance of a metallic wire would, Options are ⇒ (A) increase as the operating frequency increase, (B) decrease as the operating frequency increase, (C) remain unaffected on increasing the operating frequency, (D) first increase then decrease, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistance of a metallic wire would
A.	increase as the operating frequency increase [Wrong Answer]
B.	decrease as the operating frequency increase [Correct Answer]
C.	remain unaffected on increasing the operating frequency [Wrong Answer]
D.	first increase then decrease [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above

⇒ Which of the following is not a valid character constant in C?
A'
2'
='
2

⇒ In direct addressing mode of 8085
All instructions are 3 bytes long
All instructions are 3 bytes long except IN instruction which is 2 bytes long
All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long
All instructions are 2 bytes long

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ Positive feedback is mainly used in
oscillators
thyristors
voltage regulators
both (a) and (b)

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ The most commonly used logic family is
ECL
TTL
CMOS
PMOS

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ Drain feedback bias is often used with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ An op-amp is fed from a signal source through resistance R₁. If it is to work as sign changer, the feedback resistance R_f should be
equal to R₁
twice R₁
half R₁
either (b) or (c)

⇒ For a directional coupler the power is in the ratio of
40 dB
30 dB
20 dB
10 dB

⇒ A thyristor circuit is feeding an R-L load. The turn on time can be reduced by
decreasing R
decreasing L
increasing L
decreasing R and L together

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ In a Ballistic galvanometer
inertia is small and damping is also small
inertia is large and damping is critical
inertia is large and damping is small
both inertia and damping are large

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ In 8085 the data is stored in the stack on
First in First Out basis
Last in First Out basis
First in Last Out basis
Last in Last Out basis

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
(4000)_H - (40FF)_H
(8000)_H - (80FF)_H
(8000)_H - (40FF)_H
Any of the above

⇒

LPEPSI
3
9
13
23



⇒ As compared to a bipolar transistor, a JFET is
highly sensitive to changes in input voltage
more sensitive to changes in input voltage
less sensitive to changes in input voltage
equally sensitive to changes in input voltage

⇒ Video signals are transmitted through
amplitude modulation
frequency modulation
either amplitude or frequency modulation
neither amplitude nor frequency modulation

⇒ A current increasing at the rate of 1A/s is passed through a 1 H inductor. At t = 0, i = 0. The flux linkages after 1 sec are
0.5 Wb-turn
1 Wb-turn
2 Wb-turn
4 Wb-turn

⇒ Audio-signal modulates a 125 MHz carrier, causing a frequency deviation of 5 kHz. The bandwidth of the narrowband FM signal is __________ kHz.
10
8
9
20

⇒ The density of the dynamic RAM is
more than that of static RAM
less than that of static RAM
equal to that to static RAM
equal to or more than that of static RAM

⇒ Consider the following statements Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.
 Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒ The efficiency of a horn speaker is about
0.1
0.4
0.6
0.8

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒ The number of pins in microprocessor 8086 is
30
40
50
60

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved