Question is ⇒ The resistance of a metallic wire would, Options are ⇒ (A) increase as f increase, (B) decrease as f increase, (C) remains the same at all frequencies, (D) increase with f up to a certain frequency and then decrease, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistance of a metallic wire would, Options are ⇒ (A) increase as f increase, (B) decrease as f increase, (C) remains the same at all frequencies, (D) increase with f up to a certain frequency and then decrease, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistance of a metallic wire would
A.	increase as f increase [Correct Answer]
B.	decrease as f increase [Wrong Answer]
C.	remains the same at all frequencies [Wrong Answer]
D.	increase with f up to a certain frequency and then decrease [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage

⇒ The full form of the abbreviations TTL and CMOS in reference to logic families are
Triple Transistor Logic and Chip Metal Oxide Semiconductor
Tristate Transistor Logic and Chip Metal Oxide Semiconductor
Transistor Transistor logic and Complementary Metal Oxide Semiconductor
Trisate Transistor Logic and Complementary Metal Oxide Silicon

⇒ The admittance parameter Y₁₂ in the 2 port network in the fi
-0.2 mho
0.1 mho
-0.05 mho
0.05 mho

⇒ In a class C power amplifier the input signal has a frequency of 250 kHz. If the collector current pulses are 0.1 μs wide, the duty cycle of current waveform is
0.5
0.25
0.025
0.0025

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ In a biased JFET (Figure) the shape of the channel is as shown bec
it is the property of material used
the drain end is more reverse biased than source end
drain end is more forward biased than source end
impurity profile changes with distance

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒ The port of PC to which mouse is connected is called
serial port
parallel port
input port
scanner port

⇒ The radix of a hexadecimal system is
2
3
8
16

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ In force current analogy, displacement x is analogous to
charge
magnetic flux linkage
electrostatic energy
voltage

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered

⇒ A decade counter
counts for ten days
counts ten times faster than a binary counters
counts to 9 and reset on the next pulse
reverts on the pulse after the tenth

⇒ In a microprocessor
all instructions need only one machine cycle
some instructions need only one machine cycle while some other instructions need more than one machine cycle
all instructions need only fraction of one machine cycle
some instructions need less than one machine cycle

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒ Which of the statement is correct?
h and g matrices are inverse of each other
z and y matrices are inverse of each other
for reciprocal networks AD - BC = 1
ABCD parameters are used in transistor circuit

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ The function δ (t - b) is a
unit impulse
unit step
unit doublet
none of the above

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ The value of a in a transistor
is always equal to 1
is less than 1 but more than 0.9
is about 0.4
is about 0.1

⇒ A dielectric is subjected to alternating field. The dielectric losses are potential to
real part of dielectric constant
imaginary part of dielectric constant
both real and imaginary parts of dielectric constant
either real or imaginary part of dielectric constant

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE

⇒ When microprocessor processes both positive and negative numbers, the representation used is
l's complement
2's complement
signed binary
any of the above

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ BCD equivalent of - 8₁₀ is
110
10110
11000
1000