Question is ⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be, Options are ⇒ (A) very low, (B) low, (C) high, (D) almost zero, (E) , Leave your comments or Download question paper.

Question is ⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be, Options are ⇒ (A) very low, (B) low, (C) high, (D) almost zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
A.	very low [Wrong Answer]
B.	low [Wrong Answer]
C.	high [Correct Answer]
D.	almost zero [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Audio tapes have two tracks each 2.5 mm wide.
TRUE
FALSE

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ If the inputs to a 2 input XOR gate are high then, the output is high.
TRUE
FALSE

⇒ Which of the following is used as detector in audio frequency ac bridges?
AC voltmeter
CRO
Head phones
Vibration galvanometer

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒ The input impedance of a non-inverting amplifier is very low.
TRUE
FALSE

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ Which of these are allowed in Basic?
Arithmetic operators +, -, *, / etc.
Logical operators AND, OR, NOT
Relational operators =, <, > etc.
All of the above

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?
12 H, 0
12 H, 1
DDH, 0
DDH, 1

⇒ Symbol shown in figure represen
Enhancement only N-channel MOSFET
UJT with p-type base
N-channel DMOSFET with internal protection
Phototransistor

⇒ The system in the given figure,
good gain and phase margin
poor gain and phase margin
good gain margin but poor phase margin
poor gain margin but good phase margin

⇒ For a high pass filter, β = p in attenuation band.
TRUE
FALSE

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ The feedback resistance r_d in small signal model of MOSFET is of the order of
1000 MΩ
1 MΩ
1 KΩ
100 Ω

⇒ Computers 'Basic input output system' is generally stored in RAM chips.
TRUE
FALSE

⇒ An electrical network with 8 independent nodes will have __________ nodal equations.
4
6
7
8

⇒ The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about
1200 Ω
120 Ω
600 Ω
10 Ω

⇒ The circuit shown in the figure is best described
bridge rectifier
ring modulator
frequency discriminator
voltage doubler

⇒ As per Boolean algebra, inputs can be interchanged in
OR gates
AND gates
both OR and AND gates
none of the above

⇒ The total number of leads in reverse conducting thyristor is
2
3
1
4

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin

⇒ Radiation efficiency of an antenna is defined as the ratio of
Total power radiated by an antenna to the net power accepted by the antenna from the connected transmitter
The frequency at which minimum power is radiated to the frequency at which maximum power is radiated
Total power accepted from the transmitter to total power generated by the transmitter
Power in main lobe to that in the side lobe

⇒ It is desired to design a phase shift oscillator using an FET having a g_m = 5000 μSiemen, r_d = 40 kΩ and feedback circuit value of R = 10 K. Then value of C for oscillator operation at 1 kHz and that of R_D for A = 40 to ensure oscillator action are
6.4 nF, 80 K
6.5 nF, 10 K
6.5 pF, 10 K
65 pF, 80 K

⇒ It is required to trace the output characteristics of a CE bipolar transistor on a CRO screen. The proper method is
apply the voltage drop across collector resistance to Y input, disconnect sweep generator and apply V_CE to X input
apply voltage drop across collector resistance to Y input
apply V_CE to X input
apply V_CE to Y input, disconnect the sweep generator and apply voltage drop across collector resistance to X input

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ Consider the following advantages of phase array radar

simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning

Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only

⇒ Which liquid crystal is used for LCD display?
Mercury
Pneumatic fluid
Aqua regia
Liquid boron

⇒ A reflex klystron oscillator uses
one cavity resonator
two cavity resonators
three cavity resonators
none of the above

⇒ For any given two port network, any parameter set can be determined from measurements made at the two ports.
TRUE
FALSE