Question is ⇒ The relative stability of a system is given by, Options are ⇒ (A) gain margin alone, (B) phase margin alone, (C) both phase and gain margins, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ The relative stability of a system is given by, Options are ⇒ (A) gain margin alone, (B) phase margin alone, (C) both phase and gain margins, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The relative stability of a system is given by
A.	gain margin alone [Wrong Answer]
B.	phase margin alone [Wrong Answer]
C.	both phase and gain margins [Correct Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A class C chopper can operate in first and second quadrants

Reason (R): A class B chopper operates only in second quadrant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In PCM the amplitude levels are transmitted in a 7 unit code. Sampling frequency is 10 kHz. The bandwidth should be
5 kHz
35 kHz
70 kHz
5 MHz

⇒ The potential that appears at a point in space due to the current which caused it is called potential
accelerating
retardation
oscillating
lagging the current

⇒ For the single rectangular pulse of the given fi
TRUE
FALSE

⇒ At room temperature, the current in the, intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒ Which device changes serial data to parallel data?
Counter
Multiplexer
Demultiplexer
Flip flop

⇒ Maximum rectification efficiency for a half wave rectifier is
1
0.88
0.5
0.406

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ Oscillator crystal is made of
silicon
germanium
diamond
quartz

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
6 dB and 180°
3 dB and 180°
6 dB and 90°
3 dB and 90°

⇒ For transmission-line matching over range of frequencies, it is best to use a
single stub of adjustable position
double stub
broadband directional coupler
balun

⇒ When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like
narrow pulses
half sine wave
almost sine wave
either (a) or (b)

⇒ Which of the following conditions must be satisfied for a transistor to remain under saturation?

Its collector to base junction should be under forward bias.
Its collector to base junction should be under reverse bias.
Its emitter to base junction should be under reverse bias.
Its emitter to base junction should be under forward bias.

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
1 and 4

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ A DIAC has two terminals, anode and cathode.
TRUE
FALSE

⇒ The current in a p-n junction diode with V volts applied in p region relative to n region (where I₀ is reverse saturation current, m is ideality factor, k is Boltzmann's constant, T is absolute temp and q is charge on electron) is
I₀ (e^-qV/mkT - 1)
I₀ e^-qV/mkT
I₀ (e^qV/mkT)
I₀ (e^qV/mkT - 1)

⇒ The emf of a Weston cell is 1.286 V.
TRUE
FALSE

⇒ Which of the following oscillator circuits uses three capacitors in the phase shifting network?
Hartley
Clapp
Colpitt's
Both (b) and (c)

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ When transient and steady state response require improvement; a __________ is used.
Lead compensator
Lag - Lead compensator
Lag compensator
Integrator

⇒ If f(t) ↔ F(jω), f(- t) ↔
- F(jω)
F(- jω)
F(jω)
0.5 F(jω)

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒ For the characteristic equation s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 = 0, the number of roots in left half s plane are
1
2
3
5

⇒ In control systems the word controller includes
error detector and feedback element
feedback element and control elements
error detector and control elements
error detector, control elements and feedback elements

⇒ An ammeter is
secondary instrument
absolute instrument
recording instrument
integrating instrument

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞