Question is ⇒ The relation between bandwidth B, modulating frequency fm and frequency deviation Δf for a sinusoidally modulated FM signal is, Options are ⇒ (A) B = Δf + fm, (B) B = 2(Δf + fm), (C) B = fm - Δf/, (D) B = 2(fm - Δf), (E) , Leave your comments or Download question paper.

Question is ⇒ The relation between bandwidth B, modulating frequency fm and frequency deviation Δf for a sinusoidally modulated FM signal is, Options are ⇒ (A) B = Δf + fm, (B) B = 2(Δf + fm), (C) B = fm - Δf/, (D) B = 2(fm - Δf), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
A.	B = Δf + f_m [Wrong Answer]
B.	B = 2(Δf + f_m) [Correct Answer]
C.	B = f_m - Δf/ [Wrong Answer]
D.	B = 2(f_m - Δf) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ Which of the following counters can be used to divide the clock frequency of a microprocessor by 5?
3 bit counter
5 bit counter
mod 3 counter
mod 5 counter

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ Consider the following symbols

Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )

Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ A cycloconverter cannot give a frequency higher than input frequency.
TRUE
FALSE

⇒ When a wave reaches the open circuited end of a line
all the forward energy is reflected by the open circuit
all the forward energy is absorbed by the open circuit
a small portion of energy is radiated into atmosphere and the remaining energy is reflected
either (a) or (b)

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ Robotic manipulator arms mostly use
hydraulic actuator
pneumatic actuator
electric motor actuator
none of the above

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation

⇒ The current due to thermionic emission is given by Richardson Dushman equation.
TRUE
FALSE

⇒

Match the following:

	List I (Component)		List II (Dominant TE mode)
A.	Rectangular wave guide	1.	TE₁₀₁
B.	Circular waveguide	2.	TE₁₀
C.	Rectangular cavity	3.	TE₁₁₁
		4.	TE₁₁

A-4, B-2, C-1
A-2, B-1, C-3
A-3, B-4, C-1
A-2, B-3, C-1

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above

⇒ Johnson noise is
white for all Practical application
always white
depends on temperature
never white

⇒ Which of the following amplifiers is used for impedance matching?
CE
CC
CB
Push pull

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ Following is a reason of distortion in communication system
external interference
random variations
insufficient Channel Bandwidth
all

⇒ Antenna reciprocity is put to use in
radar system
commercial broadcast
TV broadcast system
none of the above

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ The forbidden energy gap for silicon is
0.12 eV
1.12 eV
0.72 eV
7.2 eV

⇒ δ(t - b) is a pulse function.
TRUE
FALSE

⇒ Polar plot of a lag-lead compensator is a circle.
TRUE
FALSE

⇒ Find 'X' in the circuit bel
p(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ The address to which a software or hardware restart branches is known as
Vector location
SID
SOD
TRAP

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation in parameters of active device.

Reason (R): A large negative value of feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to the feedback factor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong