Question is ⇒ The register set and instruction set of 8088 is similar to that of, Options are ⇒ (A) 8085, (B) 8086, (C) partly 8085 and partly 8086, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The register set and instruction set of 8088 is similar to that of, Options are ⇒ (A) 8085, (B) 8086, (C) partly 8085 and partly 8086, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The register set and instruction set of 8088 is similar to that of
A.	8085 [Wrong Answer]
B.	8086 [Correct Answer]
C.	partly 8085 and partly 8086 [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ Which are of the following oscillators is well suited for the generation of wide range audio-frequency sine waves?
RC phase-shift oscillator
Wien-bridge oscillator
Colpitts oscillator
Hartley oscillator

⇒ In degenerate p type semiconductor material, the Fermi level,
is in the valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near conduction band

⇒ Out of S, R, J, K, Preset, Clear inputs to flip flops, the synchronous inputs are
S, R, J, K only
S, R, Preset, Clear only
Preset, Clear only
S, R only

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz

⇒ The range of floating point numbers in Java is
1.4 E - 45 to 3.4 E + 38
3.4 E - 45 to 1.4 E + 38
1.4 E - 38 to 3.4 E + 45
3.4 E - 38 to 1.4 E + 45

⇒ When Schrodinger equation is applied to the motion of electron in the field of protons, the physically acceptable solutions for the wave function exist for quantum number which are
2
3
4
5

⇒

Assertion (A): Schering bridge is a low voltage bridge.

Reason (R): Schering bridge is very commonly used for measurement of capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a flip-flop with a NAND latch, a low R and a low S produces
active condition
inactive condition
race condition
dead condition

⇒ Distilled water at 25°C is characterized by σ = 1.7 x 10^-4 mho/m and ε = 78 ε₀ at a frequency of 3 GHz. Its loss tangent is (ε = 10^-9/36p F/m)
1.3 x 10^-5
1.3 x 10^-3
1.7 x 10^-4/78
1.7 x l0^-4/78ε₀

⇒

Assertion (A): TTL is a very popular logic in SSI and MSI category.

Reason (R): In Schottky TTL the power dissipation is less than in ordinary TTL.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In an intrinsic semiconductor, the intrinsic charge concentration at any absolute temperature T is proportional to
T
T²
T³
T⁴

⇒ In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition
A_v → ∞
1 << A_v → ∞
A_v ≈ 1
A_v << 1

⇒ The ripple factor for a bridge rectifier is
0.406
1.21
1.11
2.22

⇒

Assertion (A): Damping in a vibration galvanometer is small.

Reason (R): Vibration galvanometer is a PMMC instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a class C power amplifier the input frequency of ac signal is 1 MHz. If tank circuit has C = 1000 pF, the value of L =
25 μH
50 μH
100 μH
200 μH

⇒ In the circuit of figure, the source supplies, 2.25 mA. The value of R mus
5 Ω
3 Ω
1.5 Ω
0.5 Ω

⇒ In a series RLC circuit, p-f is leading if X_C < X_L.
TRUE
FALSE

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ In radio receiver, the maximum contribution to noise is from
mixer stage
power supply
power amplifier
equally from above three

⇒ Which of the following is a valid integer variable in Fortran 77?
KM
K M - 1
DELHI
318

⇒ From the given circuit below, we can conclude t
BJT is pnp
BJT is npn
transistor is faulty
not possible to determined

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ Which of these has peak and valley points in v-i curve?
Tunnel diode
Zener diode
PIN diode
Schottky diode

⇒ The contents of the program counter after the call operation wil
(30F0)_H
(40F0)_H
(50F0)_H
(60F0)_H

⇒ Which is not a software?
DOS
Windows
MS WORD
Hard disk

⇒ It is required to study transients during switching process. Which CRO should be preferred?
Ordinary CRO
Dual beam CRO
Dual trace CRO
Storage oscilloscope

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true