Question is ⇒ The reason for glitches on the outputs of decoding gates on a synchronous counter is, Options are ⇒ (A) FFs changing states together, (B) FFs changing states one at a time, (C) AND gates not functioning properly, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The reason for glitches on the outputs of decoding gates on a synchronous counter is, Options are ⇒ (A) FFs changing states together, (B) FFs changing states one at a time, (C) AND gates not functioning properly, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The reason for glitches on the outputs of decoding gates on a synchronous counter is
A.	FFs changing states together [Wrong Answer]
B.	FFs changing states one at a time [Correct Answer]
C.	AND gates not functioning properly [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ A NAND gate has 3 inputs and one output. The number of thyristors required for this gate are
1
2
3
3 or 4

⇒ If each stage has a gain of 10 dB and noise figure of 10 dB, then the overall noise figure of a two stage cascade amplifier will be
10
1.09
1
10.9

⇒ Electronic tubes used for transmitter differ from their counterparts in the receivers in respect that
they are large in size
they are capable of handling large powers
they generate large amount of heat when in operation
none of the above

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ Consider the following:

A TV receiver antenna should pick up the TV signal and develop maximum voltage from the available strength of signal
It should reject unwanted signals
It should not suffer from co-channel interference
It should have a very narrowband

The correct statements are
1 and 2 only
1, 2 and 3 only
1, 2, 3, 4
2, 3 only

⇒ Choose the correct option

Mesh is the smallest loop of circuit
Loop is smallest path of circuit
Loop does not contain any mesh
Loop may have one or more than one mesh

1, 2, 3, 4
3, 4, 2
1, 4
3, 2

⇒ Half power point directions for broadside is
60°
30°
45°
at any angle

⇒ In a bipolar transistor which current is largest
collector current
base current
emitter current
base current or emitter current

⇒ The hex number EB₁₆ represents binary number of
11101011
10010110
10101100
11101011

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ Figure shows the arrangement
FM
PM
AM-DSB
AM-SSB

⇒ Which of the follow
Voltage series feedback and decrease I/P impedance.
Voltage shunt feedback and decrease I/P impedance.
Voltage series feedback and increase I/P impedance.
Voltage shunt feedback and increase I/P impedance.

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ Forbidden energy gap in germanium at 0 K is about
10 eV
5 eV
2 eV
0.78 eV

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ In the above case the modulation index will be
9.6
28.8
57.6
100

⇒ In floating point representation, the number of bits of mantissa is
10
9
8
7

⇒ UHF range is
30 MHz to 300 MHz
300 MHz to 3000 MHz
3000 MHz to 30, 000 MHz
above 30, 000 MHz

⇒ An electron for which l = 0 has zero orbital magnetic dipole moment.
TRUE
FALSE

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt

⇒ In figure the phase
will be 90° at ω = 0 and 0° at ω = ∞
will be 0° at ω = 0 and 90° at ω = ∞
will be 45° at ω = 0 and 0° at ω = ∞
will be 45° at ω = 0 and 90° at ω = ∞

⇒ A capacitor having capacitance C is raised to voltage V. The energy stored will be
CV²
V²/C
0.5 V²C
0.5 C²V

⇒ EPROM can be
UVPROM
EEPROM
both UVPROM and EEPROM
none of the above

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz
6.28
62.8
8
0

⇒ If a signal f(t/2) has energy is E/n then energy of the signal f(nt) is equal to __________ (n is constant)
E/2n²
2E/n²
E/n²
2En²