Question is ⇒ The range of RTD using platinum is about, Options are ⇒ (A) -100° C to 700°C, (B) -200°C to 1000°C, (C) 100°C to 1000°C, (D) about 500°C, (E) , Leave your comments or Download question paper.

Question is ⇒ The range of RTD using platinum is about, Options are ⇒ (A) -100° C to 700°C, (B) -200°C to 1000°C, (C) 100°C to 1000°C, (D) about 500°C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The range of RTD using platinum is about
A.	-100° C to 700°C [Correct Answer]
B.	-200°C to 1000°C [Wrong Answer]
C.	100°C to 1000°C [Wrong Answer]
D.	about 500°C [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ At room temperature, the current in intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ In a series R-L-C circuit, the voltage across inductance will be maximum
at resonance frequency
just before resonant frequency
just after resonant frequency
none of the above

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ The input 3-dB frequency is :
100 Hz
148 Hz
100 kHz
None

⇒ DC ampere hour meter is an indicating instrument.
TRUE
FALSE

⇒ As regards single phase dual converter
the change in operation from one quadrant to the other is faster in non-circulating current mode
the change in operation from one quadrant to the other is faster in circulating current mode
the time response to change in operation from one quadrant to other is the same in both the modes
the time response to change in operation from one quadrant to the other may be faster in any of the two modes

⇒ In the periodic train of rectangular pulses F₀ = (V₀/T)d
TRUE
FALSE

⇒ In equally tampered scale, frequency of each tone equals the frequency of lower adjacent tone multiplied by
(2)^1/7
(2)^1/12
(2)^1/6
(2)^1/5

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ For a given magnetic material operating in linear mode B = 0.06 T. Assume permeability = 51, then magnetization is:
44836 A/m
46834 A/m
946 A/m
936 A/m

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease

⇒ Which of the following assembler directives in 8085 does not cause any memory location to be used μp?
D S
D B
D W
E Q U

⇒ The cut off wavelength λ_c for TE₂₀ mode for a standard rectangles waveguide is
2/a
2a
a
2a²

⇒ In a stop-and-wait ARQ system, the transmitting terminal
waits for positive or negative acknowled-gement from the receiving terminal after sending a block
sends another block if positive acknowledge is received through ACK character
resends the previous block if negative acknowledgement is received through a NAK character
does not wait for acknowledgement after sending a block

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ The two conductors of a transmission line carry equal current I in opposite direction. The force on each conductor is
proportional to I
proportional to I²
proportional to distance between the lines
proportional to I³

⇒ In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is
1.92 ms
2.08 ms
50 ms
0.08 ms

⇒ In common base configuration, the input characteristics of bipolar junction transistor are drawn between
V_EB and I_E
V_CB and I_C
I_C and V_CE
I_E and V_CE

⇒ The equivalent of the block diagram in figure is give
Figure (a)
Figure (b)
Figure (c)
Figure (d)

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ Consider the following program for 8085OACH
53 H
OADH
54 H

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ In molecules of ionic crystals, orientation polarization is zero.
TRUE
FALSE

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math