Question is ⇒ The race condition in NOR SR latch occurs when, Options are ⇒ (A) S = R = 1, (B) S = 0, R = 1, (C) S = 0, R = 0, (D) S = 1, R = 0, (E) , Leave your comments or Download question paper.

Question is ⇒ The race condition in NOR SR latch occurs when, Options are ⇒ (A) S = R = 1, (B) S = 0, R = 1, (C) S = 0, R = 0, (D) S = 1, R = 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The race condition in NOR SR latch occurs when
A.	S = R = 1 [Correct Answer]
B.	S = 0, R = 1 [Wrong Answer]
C.	S = 0, R = 0 [Wrong Answer]
D.	S = 1, R = 0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The pre-emphasis in FM aids in providing extra noise immunity by
emphasizing only the higher frequency components
emphasizing the entire frequency band
emphasizing only the lower frequency band
cutting down the low frequency noise

⇒ Binary 1000 multiplied by binary 1000 gives
10000
100000
1000000
10000000

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒ In CCD
a small charge is deposited for logical 1
a small charge is deposited for both logical 1 and 0
a small charge is deposited for logical 0 and large charge for logical 1
none of the above

⇒

Assertion (A): The conductivity of p type semiconductor is higher than that of intrinsic semiconductor.

Reason (R): The addition of donor impurity creates additional energy levels below conduction band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒ What is the purpose of peak clipper circuits in radio transmitters?
To prevent overmodulation
To reduce bandwidth
To increase bandwidth
To regulate oscillator I/P voltage

⇒ In an AM transmitter after the modulation stage, class C amplifier
can be used
cannot be used
may be used, but it has no use
can't be determine to use

⇒ In intrinsic semiconductor at 300 K, the magnitude of free electron concentration in silicon is about
15 x 10⁴ per cm³
5 x 10¹² per cm³
1.45 x 10¹⁰ per cm³
1.45 x 10⁶ per cm³

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation

⇒ A hertzian dipole has a radiation pattern with
a null in the direction of the dipole
a null in the plane perpendicular to the dipole
a peak in the direction of the dipole
none of the above

⇒ Point out the false statem
Building, for the time, a body-stabilized geosynchronous communication satellite with its own apogee propulsion and control systems
Attitude control and station management operations for a geostationary satellite
Building launching rocket Ariane for putting APPLE in orbit
Domestic communications on an experimental basis

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All

⇒ The elements which become superconducting at extremely low temperatures are
good conductors at room temperature
ferromagnetic at room temperature
relatively poor conductors at room temperature
insulators at room temperature

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ TTL is used in electronic calculators.
TRUE
FALSE

⇒ Which memory requires periodic recharging?
All ROMS
All RAMS
Static RAM
Dynamic RAM

⇒ A capacitor used for power factor correction is single phase circuit decreases
power factor
line current
both line current and p.f.
the line current and increases p.f.

⇒ The component in the given figur
attenuator
T type low pass filter
T type high pass filter
phase shifter

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only

⇒ In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
are always similar
can never be similar
may be similar or dissimilar
are similar only if a = 0

⇒ When two 4 bit parallel adders are cascaded we get
4 bit parallel adder
8 bit parallel adder
16 bit parallel adder
none of the above

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ P flag is for parity.
TRUE
FALSE

⇒ Dielectric constant of transformer oil is about
1
4
10
20

⇒ The general purpose register code for accumulator in 8085 is
111
0
1
1111

⇒ The equivalent of the block diagram in figure is give
Figure (a)
Figure (b)
Figure (c)
Figure (d)

⇒ If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
40 km
110 km
400 km
1100 km