Question is ⇒ The problem of current lagging is associated with, Options are ⇒ (A) DCTL gates, (B) DTL gates, (C) ECL gates, (D) CMOS gates, (E) , Leave your comments or Download question paper.

Question is ⇒ The problem of current lagging is associated with, Options are ⇒ (A) DCTL gates, (B) DTL gates, (C) ECL gates, (D) CMOS gates, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The problem of current lagging is associated with
A.	DCTL gates [Correct Answer]
B.	DTL gates [Wrong Answer]
C.	ECL gates [Wrong Answer]
D.	CMOS gates [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒ Microwave link repeaters are typically 50 km apart in TV transmission due to
atmosphere attenuation
output power tube limitations
attenuation of surface wave
earth's curvature

⇒ Long distance short-wave radio broadcasting uses
ground wave
ionospheric wave
direct wave
any of the above

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ An antenna having an effective temperature of 27°K is fed into a microwave amplifier that has an effective noise temperature of 30 K. Calculate the available noise power per unit bandwidth
30 K
57 K
27 K
3K, K is Boltzmann constant

⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18

⇒ The adjustment of position of shading bands, in an energy meter, is done to provide
friction compensation
creep compensation
braking torque
none of the above

⇒ In the circuit shown, the power supplied by the voltage so
0 W
5 W
10 W
100 W

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ The electric breakdown strength is affected by
shape of the waveform of applied voltage
steepness of the wavefront of the applied voltage
composition of the material
all of the above

⇒ In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.
TRUE
FALSE

⇒ In cable TV local programmes can be telecast at any frequency.
TRUE
FALSE

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ For the system in the given figure G varies slightly, the ratio of open loop sensitivity to closed loop sensitivit
1 : (1 + GH)
1 : (1 + GH)^-1
1 : (1 - GH)
1 : (1 - GH)^-1

⇒ Pick out the odd one
stochastic variable
stochastic function
random variable
random experiment

⇒ The decorative lighting works on the principle of
periodic switching on and off
special inverter
rectifier
motor

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ The ideal characteristics of a stabilizer is
constant output voltage with low internal resistance
constant output current with low internal resistance
constant output voltage with high internal resistance
constant internal resistance and constant output current

⇒ In 8085, to disable the whole interrupt system (except TRAP)
the DI instruction may be used
the DO instruction may be used
the INTERRUPT instruction may be used
the El instruction may be used

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ The minimum decimal equivalent of the number 11C0 is
183
194
268
269

⇒

Assertion (A): A good algorithm should be fast, require minimal computer memory and time.

Reason (R): Many times an algorithm is prepared in the form of a flow chart.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a FET, g_m varies as
I_DS
I_DS2
1/IDS
I_DS

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of
6
1
8
9

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ With respect to the following 555 timer circuit what will be the value of R_A and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_f = 1.4 V, Vo _on = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω

⇒ In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will
decrease
increase
remain the same
increase or decrease

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math