Question is ⇒ The probability of recombination of electrons and holes in a semiconductor is proportional to, Options are ⇒ (A) density of electrons, (B) density of holes, (C) density of electrons and holes, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The probability of recombination of electrons and holes in a semiconductor is proportional to, Options are ⇒ (A) density of electrons, (B) density of holes, (C) density of electrons and holes, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The probability of recombination of electrons and holes in a semiconductor is proportional to
A.	density of electrons [Wrong Answer]
B.	density of holes [Wrong Answer]
C.	density of electrons and holes [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a NOR SR latch the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 0, R = 0
S = 1, R = 0

⇒ A mod-10 counter can divide the clock frequency by a factor of
10
20
210
102

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒

Assertion (A): BCD code is used in pocket calculators

Reason (R): BCD code is slower than binary.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For an RC admittance function
the lowest critical frequency is a zero
the highest critical frequency is a pole
the lowest critical frequency is zero and the highest critical frequency is a pole
the lowest critical frequency is a pole

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

⇒ If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is
0.05
0.5
50
500

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ In the graphical analysis of an amplifier circuit, the slope of dc load line depends on
load resistance only
collector supply voltage only
both load resistance and collector supply voltage
none of the above

⇒ A TV picture is to be transmitted over a channel of 6 MHz bandwidth at a 35 dB S/N ratio. The capacity of the channel is
50 Mbps
100 Mbps
36 Mbps
72 Mbps

⇒ The interface chip for 8086 and 16 bit ADC is
8259
8255
8253
8251

⇒ In a shunt-shunt negative feedback amplifier, as compared to the basic amplifier
both input and output impedances, decrease
input impedance decreases but output impedance increase
I/P impedance increases but O/P impedance decreases
both input and O/P impedance increases

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ At FM demodulator output noise power density
increases with frequency
decreases with frequency
remains unaltered
none of the above

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒

Assertion (A): Ferrites are very useful at very high frequencies.

Reason (R): Ferrites have high permeability and high resistivity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The current wave shape shown in figure (1) is applied to a circuit element. The voltage across the element is shown in figure (2). The element
R
L
C
Semiconductor

⇒ Which of the following is a circularly polarized antenna?
Horn
Dipole
Helical
Pyramidal

⇒ A class C amplifier has input frequency of 200 kHz. If width of collector pulses is 0.1 μs, duty cycle is
0.01
0.02
0.1
0.2

⇒ For a 4096 x 8 EPROM, the number of address lines is
14
12
10
8

⇒ Which of the following devices has two gates?
SCR
SCS
SUS
SBS

⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE

⇒ Bit is a unit of
entropy
information
channel capacity
rate of information

⇒ In a ferromagnetic material, the internal field seen by a dipole is
equal to applied field
equal to applied field minus a contribution from neighbouring dipoles
equal to applied field plus a contribution from neighbouring dipoles
equal to or less than applied field

⇒ An SSB-AM signal cannot be demodulated by
Balanced modulator
Complete phase shift generator
Diode balanced modulator
Product detector

⇒ In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v₀ will
50 mV
5 mV
0.1 mV
zero

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ The colour of an object is decided by
the reflected colour
the wavelength transmitted through it
reflected colour for opaque object and wavelength transmitted through it for transparent objects
none of the above