Question is ⇒ The primary colours are, Options are ⇒ (A) blue and green, (B) blue and red, (C) red and green, (D) blue, red and green, (E) , Leave your comments or Download question paper.

Question is ⇒ The primary colours are, Options are ⇒ (A) blue and green, (B) blue and red, (C) red and green, (D) blue, red and green, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The primary colours are
A.	blue and green [Wrong Answer]
B.	blue and red [Wrong Answer]
C.	red and green [Wrong Answer]
D.	blue, red and green [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements: The radar pulse must be flat topped to

allow accurate range measurement
allow good minimum range
prevent frequency changes in magnetron
make the returned echoes easier to distinguish from noise.

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ In the circuit shown in the figure, the current supplied by the sinusoidal current source
28 A
0.166666666666667
20 A
not determinable from the data given

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ At room temperature a semiconductor material is
perfect insulator
conductor
slightly conducting
any of the above

⇒

Assertion (A): Maxwell bridge is for measuring inductance of medium magnitude.

Reason (R): In Maxwell's bridge the unknown inductance is measured by comparing it with a capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
2.16 x 10⁴ A/cm²
1.08 x 10⁴ A/cm²
4.32 x 10³ A/cm²
6.48 x 10² A/cm²

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ Which of the following statements is not correct?
Propagation delay is the time required for a gate to change its state
Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state
Fan-in of a gate is always equal to fan-out of the same gate
Operating speed is the maximum frequency at which digital data can be applied to a gate

⇒ Which of the following is not correct in C?
6 / 4 = 1
2 / 5 = 0
2.0 / 5 = 0
2.0 / 5.0 = 0.4

⇒ The voltage drop per ampere-metre of an aluminium conductor is higher as compared to a copper conductor of the same size due to its higher
insulation resistance
resistivity
conductivity
current density

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ The transfer function of a zero-order-hold system is :
(l/s)(l + e^-sT)
(1/s)(1 - e^-sT)
1 - (l/s)e^-sT
1 + (1/s)e^-sT

⇒ Pulse modulation is used in
radio navigation
automatic landing equipment
data communications
all of the above

⇒ By connecting external resistances to a differential amplifier we can adjust
voltage gain
bandwidth
both voltage gain and bandwidth
none of the above

⇒ When a wave reaches the open circuited end of a line
all the forward energy is reflected by the open circuit
all the forward energy is absorbed by the open circuit
a small portion of energy is radiated into atmosphere and the remaining energy is reflected
either (a) or (b)

⇒ Consider a silicon p-n junction at room temperature having the following paramet
is 0.70V
is 0.76V
is 0.82V
cannot be estimated from the data given

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ The main advantage of TWT over klystron is
higher bandwidth
higher gain
higher frequency
higher output

⇒ Ferromagnetic materials
shows spontaneous magnetisation below a certain temperature
have resistivity very high as compared to that of iron
can be used even at microwave frequencies
all of the above

⇒ In the vacuum diode equation i_b = ke_b^1.5, the current is
temperature limited current
space charge limited current
any of the above
none of the above

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒ If V_in is 0.99 V, what is the digital output of the ADC 0801 after INTER goes low?
0011 0011
0101 1111
0111 1100
1111 1111

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. Which of the following will increases from this type of operation?
Stability
Bandwidth
Distortion
Input resistance

⇒ In case of probability of the message is 1 to 16 then the information will be
16 bits
8 bits
4 bits
2 bits

⇒ In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is
1.92 ms
2.08 ms
50 ms
0.08 ms

⇒ In a single phase cycloconverter with centre tapped transformer
all thyristors carry currents for equal duration
the durations of currents in all thyristors may or may not be equal
the durations of currents in all thyristors cannot be equal
the duration of currents in all thyristors must be equal for satisfactory operation

⇒ If a two-port network is reciprocal as well as symmetrical, which one of the following relationships is correct?
Z₁₂ = Z₂₁ and Z₁₁ = Z₂₂
Y₁₂ - Y₂₁ and Y₁₁ - Y₂₂
AD - BC = 1 and A = D
all of the above