Question is ⇒ The presence of ozone due to corona is harmful because it, Options are ⇒ (A) reduces pawer factor, (B) corrodes the material, (C) gives odour, (D) transfer energy to the ground, (E) none of the above, Leave your comments or Download question paper.

Question is ⇒ The presence of ozone due to corona is harmful because it, Options are ⇒ (A) reduces pawer factor, (B) corrodes the material, (C) gives odour, (D) transfer energy to the ground, (E) none of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	The presence of ozone due to corona is harmful because it
A.	reduces pawer factor [Wrong Answer]
B.	corrodes the material [Correct Answer]
C.	gives odour [Wrong Answer]
D.	transfer energy to the ground [Wrong Answer]
E.	none of the above [Wrong Answer]
View Answer 7 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In which of the following cases shunt capacitance is negligible ?
Short transmission lines
Medium transmission lines
Long transmission lines
All transmission lines

⇒ Owing to skin effect
current flows through the half cross-section of the conductor
portion of the conductor near the surface carries more current and core of the conductor carries less current
portion of the conductor near the surface carries less current and core of the conductor carries more current
any of the above

⇒ In aluminium conductors, steel core is provided to
compensate for skin effect
neutralise proximity effect
reduce line inductance
increase the tensile strength

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ Corona results in
radio interference
power factor improvement
better regulation
none of the above

⇒ Large industrial consumers are supplied electrical energy at
400 V
11 kV
66 kV
400 kV

⇒ Induction regulators are used for voltage control in
alternators
primary distribution
secondary distribution
none of the above

⇒ Poles which carry transformers are usually
circular
I-type
A-type
H-type

⇒ In overhead transmission lines the effect of capacitance can be neglected when the length of line is less than
80 km
110 km
150 km
210 km

⇒ With which of the following are step-up substations associated ?
Concentrated load
Consumer location
Distributors
Generating stations

⇒ As compared to a 2-wire D.C. distributor, a 3-wire distributor with same maximum voltage to earth uses only
31.25 percent of copper
33.3 percent of copper
66.7 percent of copper
125 percent of copper

⇒ Which of the following are the constants of the transmission lines ?
Resistance
Inductance
Capacitance
All of the above

⇒ Solid grounding is adopted for voltages below
100 V
200 V
400 V
660 V

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ Which of the following D.C. distribution system is the simplest and lowest in first cost, ?
Radial system
Ring system
Inter-connected system
None of the above

⇒ When an alternator connected to the bus-bar is shut, down the bus-bar voltage will
fall
rise
remain unchanged
none of the above

⇒ The following system is not generally used
1-phase 3 wire
1-phase 4 wire
3-phase 3 wire
3-phase 4 wire

⇒ ____ are the conductors, which connect the consumer's terminals to the distribution
Distributors
Service mains
Feeders
None of the above

⇒ Electro-mechanical voltage regulators are generally used in
reactors
generators
transformers
all of the above

⇒ Which of the following bar schemes is the most expensive ?
Double bus-bar double breaker
Ring bus-bar scheme
Single bus-bar scheme
Main and transfer scheme

⇒ The electrostatic stress in underground cables is
zero at the conductor as well as on the sheath
same at the conductor and sheath
minimum at the condactor and minimum at the sheath
maximum at the conductor and minimum at the sheath

⇒ The charging current in the cables
leads the voltage by 180°
leads the voltage by 90°
lags the voltage by 90°
lags the voltage by 180°

⇒ If variable part of a.nnual cost on account of interest and depreciation on the capital outlay is equal to the annual cost of electrical energy wasted in the conductors, the total annual cost will be minimum and the corresponding size of conductor will be most economical. This statement is known as
Kelvin's law
Ohm's law
Kirchhoffs law
Faraday's law

⇒ As compared to cables, the disadvantage of transmission lines is
inductive interference between power and communication circuits
exposure to lightning
exposure to atmospheric hazards like smoke, ice, etc.
all of the above

⇒ Transmitted power remaining the same, if supply voltage of a D.C. 2-wire feeder is increased 100 percent, saving in copper is
25 percent
50 percent
75 percent
100 percent

⇒ Conductors for high voltage transmission lines are suspended from towers to
increase clearance from ground
reduce clearance from ground
take care of extension in length during summer
reduce wind and snow loads

⇒ When the load at the receiving end of a long transmission line is removed, the sending end voltage is less than the receiving end voltage. This effect is known as
Ferranti effect
Proximity effect
Kelvin effect
Faraday effect

⇒ In transmission lines the cross-arms are made of
copper
wood
R.C.C.
steel

⇒ Constant voltage transmission entails the following disadvantage
large conductor area is required for same power transmission
short-circuit current of the system is increased
either of the above
none of the above

⇒ The conductors of the overhead lines are
solid
stranded
both solid and stranded
none of the above