Question is ⇒ The power requirements of a DRAM in active and stand by modes is about, Options are ⇒ (A) 350 mW and 5 mW respectively, (B) 350 mW each, (C) 5 mW each, (D) 350 mW and 100 mW respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ The power requirements of a DRAM in active and stand by modes is about, Options are ⇒ (A) 350 mW and 5 mW respectively, (B) 350 mW each, (C) 5 mW each, (D) 350 mW and 100 mW respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The power requirements of a DRAM in active and stand by modes is about
A.	350 mW and 5 mW respectively [Correct Answer]
B.	350 mW each [Wrong Answer]
C.	5 mW each [Wrong Answer]
D.	350 mW and 100 mW respectively [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒

Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded.

Reason (R): A high inverse voltage can destroy a p-n junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒ The analog signal given below is sampled by 600 samples per se
600 Hz
120 Hz
300 Hz
360 Hz

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode

⇒ In a T flip-flop the output frequency is
same as input frequency
half of I/p frequency
double the input frequency
none

⇒ The graph of a network has 6 branches with 3 tree branches. The minimum number of equations required for solution of network is
2
3
4
5

⇒ A meter coil has a resistance of 100 Ω and a full scale deflection current of 10 mA. To convert it into a voltmeter of 0-200 V range, the series resistance should be
20 kΩ
19.9 kΩ
1.9 kΩ
20.1 kΩ

⇒ In a clocked NAND latch, race condition occur when
R and S are high CLK is low
R and CLK are high and S is low
R, S, CLK are high
R, S, CLK are low

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has a directivity of 100 is __________ .
15.92
31.84
3.184
1.592

⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron
will be increased
will be decreased
will remain the same
either (a) or (b)

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒ If e = 10 cos (2p x 10⁸t + 20 cos 2p 10³t). The bandwidth is
10⁸ Hz
42 kHz
21 kHz
10⁸ ± 10³ Hz

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above

⇒ Which of the following is not a valid integer constant in C (for 16 bit)?
321
-162
-65321
1

⇒ The network
First order system and the pole
Second order system of the two poles are
Second order system of the poles is
none of the above

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ The logic function f(A B, C) = Σm(0, 2, 4, 5, 6) represente
i
i, ii
i, iii
i, ii, iii

⇒ In figure, V_EB = 0.6 V, β = 99. Then V_C and I_C
9.3 V and 1.98 mA respectively
4.6 V and 1.98 mA respectively
9.3 V and 0.02 mA respectively
4.6 V and 0.02 mA respectively

⇒ The two outputs of RS flip-flop are
always low
always high
either low or high
always complementary

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ (62)₁₀ in binary system is
110000
111100
111110
111111

⇒ The theoretical maximum efficiency of a half wave diode rectifier is
0.406
0.5
0.812
slightly less than 100%

⇒ Rayleigh current balance is an absolute instrument.
TRUE
FALSE

⇒ A universal shift register can shift
from left to right
from right to left
both from left to right and right to left
none of the above

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2